Invacare 9000 XDT, 9000 XT, 9000XT Recliner manual Bracket a, Installing the Amputee Bracket 9000XDT

OPTIONS

SECTION 10 OPTIONS

9000XDT (FIGURE 6)

1.Refer to the following chart or FIGURE 6 to determine the mounting position of the amputee bracket:

SEAT-	*BRACKET	AXLE SPACER	SIDE OF	AXLE MOUNTING
TO-FLOOR		POSITION	WHEELCHAIR		POSITION
		(on bracket)			(on wheelchair)
TALL	A	DOWN	RIGHT		MIDDLE
TALL	B	DOWN	LEFT		MIDDLE
ADULT	B	UP	RIGHT		BOTTOM
ADULT	A	UP	LEFT		BOTTOM
HEMI	B	UP	RIGHT		MIDDLE
HEMI	A	UP	LEFT		MIDDLE

*Note: "A" and "B" are stamped on the sides of the amputee bracket.

2.Install the amputee bracket on the wheelchair frame to the position determined in STEP 1. NOTE: Make sure the axle spacer is pointing towards the outside of the wheelchair.

3.Install the two (2) hex screws and locknuts that secure the amputee bracket to the wheel- chair.

4.Install the rear wheels onto the wheelchair. Refer to REMOVING/INSTALLING THE REAR WHEELS in SECTION 6 of this manual.

BRACKET "A"	BRACKET "B"
HEMI	HEMI
LEFT	RIGHT
LEFT	RIGHT
ADULT	ADULT
	RIGHT
LEFT

Axle Spacer Towards OUT-			Hex Screws
	SIDE of Wheelchair
REAR VIEW OF
AMPUTEE BRACKET
TALL		TALL
		LEFT
RIGHT
		Locknuts

FIGURE 6 - INSTALLING THE AMPUTEE BRACKET - 9000XDT

9000 Series 58 Part No. 1056953