Invacare 9000XT Recliner, 9000 XT Replacing the Seat Upholstery Figure, Seat and Back Section

SEAT AND BACK SECTION 5

Section 5 - Seat and Back includes the following:

Replacing the Seat Upholstery

Replacing the Back Upholstery

Adjusting the Back Height, Back Angle or Seat Depth

Adjusting the Seat Width

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.

NOTE: The procedures in this section apply to NON-RECLINER models only. For 9000XT RE- CLINER models, refer to SECTION 9 of this manual.

REPLACING THE SEAT UPHOLSTERY (FIGURE 1)

1.Remove the mounting screws that secure the existing seat upholstery to the wheel- chair frame.

NOTE: The chart below determines the number of mounting screws for each seat depth.

2.Remove the EXISTING seat upholstery from the wheelchair frame.

3.Install NEW seat upholstery by reversing STEPS 1-2.

SEAT DEPTH	NUMBER OF SCREWS
16-inch	8
17-inch to 20-inch	10
	16-inch Seat Depth

Seat Upholstery

Mounting Screws

Wheelchair Frame

FIGURE 1 - REPLACING THE SEAT UPHOLSTERY

SEAT AND BACK

Part No. 1056953 31 9000 Series