ARMS
SECTION 4 | ARMS |
Section 4 - Arms includes the following:
Adjusting Armrest Height
Replacing Desk/Full Length Armrest Pad and or Clothing Guards (Fixed Height Arms Only) Removing or Replacing Armrest
Converting From Space Saver to Conventional Arms or Conventional to Space Saver Arms (9000 XT/XDT Wheelchairs)
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attach- ing hardware is tightened securely - otherwise injury or damage may occur.
ADJUSTING ARMREST HEIGHT (FIGURE 1)
WARNING
Make sure the height adjustment lever is in the locked position be- fore using the wheelchair.
1.Unlock the armrest by flipping the height adjustment lever on the top front of the armrest to the UP (HORI- ZONTAL) position.
2.Adjust armrest to one (1) of five (5) positions.
Locked (Vertical) | Armrest | Height |
| Adjustment | |
|
| |
|
| Lever |
Unlocked (Horizontal)
NOTE: Height adjustment lever MUST be in | FIGURE 1 - ADJUSTING ARMREST |
the unlocked position when placing armrest into | HEIGHT |
the arm assembly. |
|
3.Lock the armrest by pressing the height adjustment lever into the DOWN (VERTI- CAL) position when the desired armrest height is achieved.
4.Repeat STEPS
SWING-BACK ARMS (FIGURE 2)
NOTE: This procedure applies to 9000SL, 9000XT, and 9000XDT wheelchairs ONLY.
WARNING
Make sure the armrest release lever is in the locked position before using the wheelchair.
1.Unlock the
2.Pull the front of the
3.To use the
9000 Series | 28 | Part No. 1056953 |