Invacare 9000 Series manual Replacing the Back Upholstery, Screw on Back Upholstery 9000 SL Figure

Page 32

SECTION 5

SEAT AND BACK

 

 

 

REPLACING THE BACK UPHOLSTERY

SCREW ON BACK UPHOLSTERY - 9000 SL (FIGURE 2)

SEAT BACKAND

1.Flip swing back arms up and out of the way. Refer to SWING-BACK ARMS in SECTION 4 of this manual.

2.Remove the six (6) mounting screws and washers that secure the EXISTING back upholstery to the back canes.

3.Cut the tie wraps that secure the EXIST- ING back upholstery to the wheelchair frame.

4.Securely tighten the NEW back uphol- stery to the back canes with the six (6) mounting screws and washers starting with the top hole of the back cane.

5.Install two (2) NEW tie wraps through the bottom holes of the upholstery to the bottom of the back upholstery to the back canes.

Washers

Back Upholstery

Back

Mounting

Cane

Screws

 

Tie Wraps

Washers

 

 

Mounting Screws

FIGURE 2 - REPLACING THE

SCREW ON BACK UPHOLSTERY -

9000 SL

6.Flip swing-back arms down for use. Refer to SWING-BACK ARMS in SECTION 5 of this manual.

SLIP ON BACK UPHOLSTERY - 9000 XT/XDT (FIGURE 3)

1.Remove the two (2) mounting screws and washers that secure the existing back upholstery to the back canes.

2.Remove the two (2) mounting screws and locknuts that secure one (1) back cane to the wheelchair frame.

NOTE: It is necessary to remove only one (1) back cane to replace the back upholstery.

3.Pull the loose back cane out of the existing back upholstery.

4.Pull the existing back upholstery up and over the mounted back cane.

5.Install the NEW back upholstery over the mounted back cane.

Washer

Back Upholstery

Mounting

Screws

Back Cane

NOTE: The two (2) mounting screws and lock- nuts that secure the back cane to the wheel- chair frame are not shown for clarity.

FIGURE 3 - REPLACING THE SLIP

ON BACK UPHOLSTERY -

9000 XT/XDT

6.Slide the loose back cane through the NEW back upholstery.

7.Secure the back cane to the wheelchair frame with the two (2) allen screws and locknuts.

8.Secure the NEW back upholstery to the back canes with the existing mounting screws and washers.

9000 Series

32

Part No. 1056953

Image 32
Contents Series Series Table of Contents ANTI-TIPPERS/WHEEL Locks Special Notes Special NotesLocationslabel Label LocationsXDT only XT Recliner Models onlySpecifications SpecificationsXT Recliner 9000 XDTGeneral Guidelines Information for Healthcare PROFESSIONALS/ AssistantsGeneral Guidelines Section Section General Guidelines Stability ALL ModelsANTI-TIPPERS Stability Recliner Models only Operating InformationGeneral Guidelines Tire Pressure Weight TrainingWeight Limitation Coping with Everyday Obstacles SAFETY/HANDLING of WheelchairsStability and Balance Percentage of Weight Distribution Tipping REACHING, Leaning and Bending ForwardREACHING, Leaning Backwards Tipping Curbs Method 1 Wheelchair With Step Tubes Stairways ESCALATORS? SorryTransferring to and from Other Seats Unfolding and Folding the WheelchairHammock or Sling Seat Models SOLID-SEAT ModelsSafety Inspection Safety Inspection ChecklistSafety Inspection Section Troubleshooting MaintenanceMaintenance Safety Precautions Suggested Maintenance ProceduresSafety Inspection INSTALLING/REMOVING/USING the FOOTREST/LEGREST Figure UsingRemoving Front RiggingsFront Riggings Section Footrest Height Adjustment FigureImpact GUARDS/CALF Strap Figure Heel Loop Replacement Figure ReplacementRAISING/LOWERING the Elevating Legrest Assembly Figure Adjusting the Elevating Legrest AssemblyAdjusting Armrest Height Figure SWING-BACK Arms FigureArms Section ArmsRemoving or Replacing Armrest Figure Armrest PADClothing Guard Removing ArmrestsSpace Saver ARM Position Conventional ARM Position Seat and Back Replacing the Seat Upholstery FigureSeat and Back Section Replacing the Back Upholstery Screw on Back Upholstery 9000 SL FigureSlip on Back Upholstery 9000 XT/XDT Figure Section Seat and BackAdjusting the Back HEIGHT, Back Angle or Seat Depth Adjusting the Seat WidthREMOVING/INSTALLING the Rear Wheels Permanent AxlesQUICK-RELEASE Axles Figure WheelsrearDetail a Locking Pins and Detent PIN Rear Wheels SectionRear Wheels Inside Wheelchair OutsideREPLACING/REPAIRING Rear Wheel TIRE/TUBE Replacing Rear Wheel Handrim FigureAdjusting the QUICK-RELEASE Axle Figure Adjusting the QUICK-RELEASE AxleCastersfront Section Front CastersFront Casters Section REPLACING/REPAIRING Front Caster TIRE/TUBEFront Caster Mounting Adjustments INSTALLING/ADJUSTING the ANTI-TIPPERS Installing ANTI-TIPPERS FigureAnti LOCKSTIPPERS/WHEEL Section ANTI-TIPPERS/WHEEL LocksANTI-TIPPERS/WHEEL Locks Adjusting FigureANTI-TIPPERS/WHEEL Locks Section USING/ADJUSTING the Patient Operated Wheel Locks Using the Patient Operated Wheel Locks FigureAdjusting the Patient Operated Wheel Locks Figure Wheel Locks are not BrakesBOLT-ON Wheel Locks CLAMP-ON Wheel Locks Recliner Operation Figure ReclinerSection Recliner To Healthcare PROFESSIONALS/ASSISTANTSReclined Position Recliner SectionUpright Position Replacing the Headrest Pillow Figure Replacing the HEADREST/BACK Upholstery FigureHeadrest Upholstery Back UpholsteryAdjusting HEADREST/BACK Upholstery Tension Figure Adjusting the Seat DepthSTORING/REPLACING the Spreader BAR Storing FigureReplacing Figure Rear View of 9000XT ReclinerInstalling the ANTI-TIPPERS Figure LENGTH, Height KIT NumberWith Patient Operated Wheel Locks Figure With Attendant Operated Wheel Locks FigureAdjusting Attendant Operated Wheel Locks Figure USING/ADJUSTING the Wheel LocksUsing Attendant Operated Wheel Locks Figure Step Installing the Telescoping I.V. RODInstalling the Telescoping I.V. ROD Holder Figure Installing the Telescoping I.V. ROD Support Tube Figure Adjusting the Telescoping I.V. ROD FigureSection Options InstallingOptions Installing the Solid Folding Seat Figure Installing the Crutch and Cane Carrier FigureCleaning Options SectionInstalling the Amputee Bracket Super Hemi Models only Figure Rear View Amputee Bracket Installing the Amputee Bracket ALL Models Except Super HemiBracket a Bracket B Installing the Amputee Bracket 9000XDT Bracket aWarranty WarrantyCanada
Related manuals
Manual 30 pages 6.48 Kb Manual 88 pages 25.16 Kb