Invacare 9000 Series, 9000 XT, 9000 SL Installing the Amputee Bracket ALL Models Except Super Hemi

OPTIONS SECTION 10

INSTALLING THE AMPUTEE BRACKET - ALL MODELS EXCEPT SUPER HEMI

9000SL/XT (FIGURE 5)

1.Refer to the following chart or FIGURE 5 to determine the mounting position of the amputee bracket:

SEAT-	*BRACKET	AXLE SPACER	SIDE OF	AXLE MOUNTING
TO-FLOOR		POSITION	WHEELCHAIR	POSITION
		(on bracket)		(on wheelchair)
ADULT	A	DOWN	RIGHT	TOP
ADULT	B	DOWN	LEFT	TOP
HEMI	B	UP	RIGHT	BOTTOM
HEMI	A	UP	LEFT	BOTTOM

*NOTE: "A" and "B" are stamped on the sides of the amputee bracket.

2.Install the amputee bracket on the wheelchair frame to the position determined in STEP 1. NOTE: Make sure the axle spacer is pointing towards the outside of the wheelchair.

3.Install the two (2) hex screws and locknuts that secure the amputee bracket to the wheel- chair.

4.Install the rear wheels onto the wheelchair. Refer to REMOVING/INSTALLING THE REAR WHEELS in SECTION 6 of this manual.

BRACKET "A" BRACKET "B"

Locknuts

OPTIONS

LEFT RIGHT

ADULT RIGHT

Axle Spacer Towards

OUTSIDE of Wheelchair

REAR VIEW OF

AMPUTEE BRACKET

Hex Screws

ADULT LEFT

Axle Spacer Towards

OUTSIDE of Wheelchair

HEMI LEFT HEMI RIGHT

FIGURE 5 - INSTALLING THE AMPUTEE BRACKET - 9000SL/XT

Part No. 1056953 57 9000 Series