Invacare TPO100B user manual Connecting/Positioning the Nasal Cannula, Detail a, Detail B

SECTION 6—OPERATING INSTRUCTIONS

Connecting/Positioning the Nasal Cannula

CAUTION

To ensure proper breath detection and oxygen delivery, Invacare recommends using a 7 ft (2.1 m) cannula. Tubing length not exceeding 25 ft (7.6 m) can be used with continuous flow.

NOTE: For this procedure, refer to FIGURE 6.2.

NOTE: The tubing/cannula must be connected to the transportable oxygen concentrator oxygen outlet as shown below.

NOTE: Replace the nasal cannula on a regular basis. Check with your equipment provider or physician to determine how often the cannula should be replaced.

NOTE: DO NOT share cannulas between patients.

1.Connect the nasal cannula to the transportable oxygen concentrator oxygen outlet port (DETAIL “A”).

2.Place the cannula over your ears and position the prongs in your nose as instructed by your health care provider or cannula manufacturer (DETAIL “B”).

DETAIL “A”

Oxygen Outlet

Port and

HEPA Filter

Nasal

Cannula

DETAIL “B”

FIGURE 6.2 Connecting/Positioning the Nasal Cannula

Part No 1156872 23 Invacare SOLO2™