Invacare TPO100B user manual General Guidelines

Page 9

SECTION 1—GENERAL GUIDELINES

The transportable oxygen concentrator is designed only to be used with a humidifier while using continuous flow mode. Use of this device with a humidifier in pulse flow mode may impair performance and/or damage the equipment.

When your automobile is turned Off, disconnect the car accessory power supply and remove the transportable oxygen concentrator from the automobile. NEVER allow the transportable oxygen concentrator to be stored in a very hot or cold automobile or in other similar, high or low, temperature environments. Refer to Typical Product Parameters on page 14.

DO NOT operate in temperatures below 41° F (5°C) or above 104° F (40° C) for extended periods of time.

Invacare recommends that the battery module be removed from the unit when the unit is not intended to be used for extended periods of time.

DO NOT connect the concentrator in parallel or series with other oxygen concentrators or oxygen therapy devices.

Invacare recommends that the transportable oxygen concentrator not be used for extended periods in the rain.

Close supervision is necessary when this product is used near children or physically‐challenged individuals.

Additional monitoring or attention may be required for patients using this device who are unable to hear or see alarms or communicate discomfort.

Be aware that electrical cords and/or tubing could present a tripping hazard.

A change in altitude may affect total oxygen available to you. Consult your physician before traveling to altitudes above 10,000 ft (3046 m) to determine if your flow settings should be changed.

Part No 1156872

9

Invacare SOLO2

Image 9
Contents Invacare SOLO2 Transportable Oxygen Concentrator Accessories Warning Table of Contents Special Notes Special Notes Disposal of Equipment and Accessories General Guidelines Operating Information General Guidelines Maintenance Radio Frequency InterferencePolarized Plug Instruction Unpacking Packaging and HandlingInspection StorageTechnical Description RED FeaturesNo AP/APG Typical Product ParametersExternal Power Supply Input Power InputConserver Trigger Delay SettingsWeight LPM Continuous DimensionsBattery Duration Battery Recharge TimeRegulatory Listing Location Operating InstructionsRecommendations for Optimal Performance FiltersPowering the Transportable Oxygen Concentrator Detail B DC Power Cable Detail C AC Power Adapter Detail a Battery ModuleInstalling the Battery Module Charging the BatteryBattery Time Management Prolonging Battery Life Checking Battery Charge LevelConnecting/Positioning the Nasal Cannula Detail aDetail B Remove cap from bottle Connecting the HumidifierDetail a Detail B Indicators and Audible AlarmControl/Adjustment Buttons LCD Displays Mode & Flow Adjustment Screen Typical Warning Screen Typical Alarm Screen Invacare SOLO2 Detail B LCD Display Icons Detail a Front PanelUsing the SOLO2 Transportable Oxygen Concentrator CLEANING, CARE, and Maintenance CabinetAir Intake Filter Cleaning the Humidifier Cleaning the CannulaTransportable Oxygen Concentrator Preventative Maintenance RecordTroubleshooting Troubleshooting GuideUnit is Beeping with no Lights or Display Symptom Probable Cause SolutionLCD Display Indicators Description SolutionsAcknowledgement Required Double audible beep every 15 sec Turn unit Off. Wait one minute, then Move unit to warmer, or cooler Troubleshooting Guide Ten audible beeps every 10 sec Ten audible beeps every 10 sec RED indicator Flashing Fast Continuous audible beep every half Troubleshooting Guide Make sure that car boat or motor Optional Accessories Limited Warranty Limited Warranty European Contacts European Contacts EC REP USA