Invacare TPO100B Detail a Battery Module, Detail B DC Power Cable Detail C AC Power Adapter

Page 20

SECTION 6—OPERATING INSTRUCTIONS

2.To operate from external power (AC or DC) please follow the steps below:

A.Turn off the transportable oxygen concentrator.

B.Connect the external power supply (DC power cable or AC power adapter) to the transportable oxygen concentrator.

C.Perform one of the following:

Plug the other end of the AC power adapter into a wall outlet.

Plug the other end of the DC power cable into the auto accessory outlet and start the engine.

D. Turn the transportable oxygen concentrator on.

DETAIL “A” - BATTERY MODULE

Transportable

Oxygen

Concentrator

Battery

Connections

Battery

Module

(Installed)

Battery Module

(Removed)

DETAIL “B” - DC POWER CABLE

DETAIL “C” - AC POWER

 

ADAPTER

 

 

 

Transportable Oxygen

 

Transportable

 

 

Concentrator

 

 

Connect to DC

 

Connect to AC

Oxygen

DC Power

AC Power Adapter

Power Source

Concentrator

Cable

Power Source

 

FIGURE 6.1 Powering the Transportable Oxygen Concentrator

Invacare SOLO2

20

Part No 1156872

Image 20
Contents Invacare SOLO2 Transportable Oxygen Concentrator Accessories Warning Table of Contents Special Notes Special Notes Disposal of Equipment and Accessories General Guidelines Operating Information General Guidelines Polarized Plug Instruction MaintenanceRadio Frequency Interference Packaging and Handling UnpackingInspection StorageTechnical Description Features REDTypical Product Parameters No AP/APGPower Input External Power Supply InputConserver Trigger Delay SettingsLPM Continuous Dimensions WeightBattery Duration Battery Recharge TimeRegulatory Listing Operating Instructions LocationRecommendations for Optimal Performance FiltersPowering the Transportable Oxygen Concentrator Detail a Battery Module Detail B DC Power Cable Detail C AC Power AdapterBattery Time Management Installing the Battery ModuleCharging the Battery Checking Battery Charge Level Prolonging Battery LifeDetail B Connecting/Positioning the Nasal CannulaDetail a Connecting the Humidifier Remove cap from bottleIndicators and Audible Alarm Detail a Detail BControl/Adjustment Buttons LCD Displays Mode & Flow Adjustment Screen Typical Warning Screen Typical Alarm Screen Invacare SOLO2 Detail a Front Panel Detail B LCD Display IconsUsing the SOLO2 Transportable Oxygen Concentrator Air Intake Filter CLEANING, CARE, and MaintenanceCabinet Cleaning the Cannula Cleaning the HumidifierPreventative Maintenance Record Transportable Oxygen ConcentratorTroubleshooting Guide TroubleshootingSymptom Probable Cause Solution Unit is Beeping with no Lights or DisplayAcknowledgement Required LCD Display IndicatorsDescription Solutions Double audible beep every 15 sec Turn unit Off. Wait one minute, then Move unit to warmer, or cooler Troubleshooting Guide Ten audible beeps every 10 sec Ten audible beeps every 10 sec RED indicator Flashing Fast Continuous audible beep every half Troubleshooting Guide Make sure that car boat or motor Optional Accessories Limited Warranty Limited Warranty European Contacts European Contacts USA EC REP