SECTION
LCD DISPLAY: | INDICATORS: | |
|
| |
| Ten audible beeps every 10 sec | |
| RED indicator Flashing Fast. | |
|
| |
DESCRIPTION: | SOLUTIONS: | |
|
| |
| 1. Connect transportable oxygen | |
Remaining battery capacity has been | concentrator to either AC or DC power, | |
or use an alternate charged battery | ||
completely used. Battery requires charging. | ||
Unit is turning off! | module. | |
2. If no other power source is available, | ||
| ||
| Change to another source of oxygen. | |
|
|
ACKNOWLEDGEMENT REQUIRED:
None required. Unit turns off within 30 seconds. Find alternate power and restart normally.
LCD DISPLAY: | INDICATORS: | |
|
| |
| Triple audible beep every 10 sec | |
| YELLOW indicator Flashing. | |
|
| |
DESCRIPTION: | SOLUTIONS: | |
|
|
|
| 1. | Move unit to warmer, or cooler, |
Unit is too hot, or too cold, to allow it to | surroundings. Allow unit to cool down to | |
less than 95° F (35° C), or warm up to 50° | ||
continue to operate. | F (10° C). Use AC, or DC, adapter for | |
| ||
Unit will continue to run internal fans to | power. | |
help lower, or raise, internal temperature. | 2. | Clean intake filter. |
Fans and unit will turn off after 10 minutes | 3. | Turn unit Off, then On again to retry. |
regardless of temperature. | 4. | Change to another source of oxygen |
| ||
| while waiting | |
|
|
|
ACKNOWLEDGEMENT REQUIRED:
While the unit is warming / cooling the alarm screen will remain active. The unit will turn completely off (battery mode) or return to standby screen (AC & DC mode), whenever the desired temperature is reached or 10 minutes of cooling has expired.
Invacare SOLO2™ | 42 | Part No 1156872 |