Panasonic ES8228 operating instructions Cleaning the self-cleaning recharger, Blades

	Caution for turbo mode
English	• Shaving in turbo mode may damage your skin. Turn the shaver
	off and then on again to cancel turbo mode.
	• Do not place your fingers on the On/Off switch while using the
	shaver. This may cause the shaver to turn off or enter turbo
	mode. Place your fingers on the finger rest while using the

Cleaning the self-cleaning recharger

Beard trimmings may become attached to the cleaning tray of the self-cleaning recharger. Follow the steps below to remove them. We recommend doing this each time you change the detergent cartridge.

shaver.
Replacing the system outer foil and the inner
blades.
system outer foil	once every year
inner blade	once every two years

1

1.	Be sure to remove the water
	tank and the appliance plug
	from the self-cleaning
	recharger.
	• Be careful not to spill the
	cleaning liquid.
2.	Gently wipe off any beard
	trimmings attached to the

1

2.32 3

4

1.Press the buttons and lift upwards as illustrated.

2.Remove the inner blades one at a time as illustrated.

•Do not touch the edges (metal parts) of the inner blades to prevent injury to your hand.

3.Insert the inner blades one at a time until they click as illustrated.

4.Insert the system outer foil by pushing it downwards until it clicks.

2

inside of the cleaning tray with

a cloth or tissue paper

dampened with water.

• Clean the corners and

uneven parts of the

cleaning tray with a cotton

swab dampened with water.

•Do not pull hard on the rubber blade protector at the bottom of the cleaning tray. The rubber may come off if you pull hard on it. It is only necessary to pull it up slightly.

•Warning - Do not wash or apply water to the adaptor or self- cleaning recharger. Failure to observe this may cause electric shock or result in short circuits.

10