Cleaning the shaver
English | 2 |
|
1
CLEAN
DRY
CHARGE
STATUS
SELECT
Insert the appliance plug.
Plug in the adaptor.
•Remove any soap or water on the shaver if it has been washed with hand soap or any other detergent.
Remove the protective cap and then attach the shaver.
•Turn the shaver off before attaching.
•Check that the outer foil is not deformed or damaged when you are attaching the shaver.
Press [SELECT] to select the course.
•Each time you press [SELECT], the course changes from “Clean/ Dry/Charge”“Clean/Dry”“Dry/Charge”“Dry”“Charge”.
•The courses start approximately 6 seconds after they are selected.
•The course will be aborted if the power is cut off. In this case, perform the course again from the beginning.
•Do not detach the detergent cartridge or the water tank as the cleaning liquid may spill causing a malfunction.
Course selection indications | Course completion summary |
Course | On recharger | Changeable course | | On recharger | On shaver | Time required (guide) | ||||
| clean | dry | charge | halfway through |
| clean | dry | charge | Backlight | [In the low temperature] |
Charge |
|
| * | | |
|
|
| Blinks | 1 hour |
Clean/Dry/Charge |
|
|
| | |
|
|
| Blinks | 2 hours [+30 min] |
Clean/Dry |
|
|
| | |
|
|
| – | 1 hour [+30min ] |
Dry/Charge |
|
|
| | |
|
|
| Blinks | 2 h 40 min |
Dry |
|
|
| | |
|
|
| – | 1 h 40 min |
*The lamp goes out in 6 seconds.
8