Kohler K-1215-AC, K-1200-AC, K-1201-AC, K-1205-AC Product Notices, Installer Hazard Notification

Page 10

6. PRODUCT NOTICES

A. INSTALLER HAZARD NOTIFICATION

B. FACTORY-ASSEMBLED FEATURES

DANGER: Risk of fire, electric shock, or injury to persons. Read important safety instructions on inside front cover of these instructions.

WARNING: Risk of electrical shock. A licensed electrician should make all electrical connections.

WARNING: Risk of electrical shock. Connect only to a circuit protected by a Ground-FaultCircuit-Interrupter (GFCI).

WARNING: Risk of electrical shock. Disconnect power before servicing.

WARNING: Risk of injury or property damage. Please read all instructions thoroughly before beginning installation, including the following Product Requirements.

NOTICE: Follow all local plumbing and electrical codes.

K-1201, K-1206, K-1211, K-1216, K-1221: Factory installed components include pump and air switch transmitter. No installation is needed.

K-1200, K-1205, K-1210, K-1215, K-1220: Factory installed components include pump. Wall timer is shipped attached to whirlpool harness.

The whirlpool pump and piping are factory-assembled.

WARNING: Unauthorized modification may cause unsafe operation and poor performance of the whirlpool. Do not relocate the whirlpool pump or make other modifications to the whirlpool system, as this could adversely affect the performance and safe operation of the whirlpool. Kohler Co. shall not be liable under its warranty or otherwise for personal injury or damage caused by any such unauthorized modification.

106548-CA(9437)

10

Kohler Co., Kohler WI

Page 9 Page 11
Image 10
Page 9 Page 11
Contents 106548- CA Copyright E1994 Kohler Co Important Safety Instructions Table of Contents Introduction ROUGHING-IN K-1200-AC, K-1201-AC ROUGHING-IN K-1205-AC, K-1206-AC ROUGHING-IN K-1210-AC, K-1211-AC ROUGHING-IN K-1215-AC, K-1216-AC ROUGHING-IN K-1220-AC, K-1221-AC Installer Hazard Notification Product NoticesProduct Requirements Tools Required Materials Required Installation RequirementsNEW or Replacement Installation Requirements Clearance RequirementsSubfloor Preparation Site RequirementsOLD Bath Removal Stud Pocket PreparationPartially Install Bath Drain Before Installing UnitTILING-IN Bead Installation Plumbing PreparationInstall Whirlpool Whirlpool SET-INInstall Plumbing Height AdjustmentSecure Whirlpool Electrical Connections AIR Actuator Versions Wiring Information 120 V, 60 HZ Excluding -J1 ModelsIdentify Electrical Requirements Locate Field Wiring Compartment 120 V, 60 HZ -J1 Models only Field Wiring Diagram 120 V, 60 HZ -J1 Models onlyField Wiring Control BOX Compartment 230 V, 50 HZ Connect Control BOX 230 V, 50 HZElectrical Connections Wall Timer Versions Wiring Information 120 V, 60 HZ Wall Timer VersionsWater Test Whirlpool & Electronics Complete Finish WallOptional K-1507 Apron Installation Optional K-1515 Apron Installation CLEAN-UP After Installation Complete InstallationInstall Handles and Spout START-UP Whirlpool Confirm Proper OperationOperating Sequence Probable Causes SymptomsTroubleshoot Whirlpool System Recommended ActionKohler Co., Kohler WI 106548-CA1093 106548-CA1093 Kohler Co., Kohler WI
Top Page Image Contents