Kohler K-1215-AC, K-1200-AC, K-1201-AC, K-1205-AC manual Electrical Connections Wall Timer Versions

Page 20

13. ELECTRICAL CONNECTIONS - WALL TIMER VERSIONS

A. IDENTIFY ELECTRICAL REQUIREMENTS

The model number is printed on a plate at the pump end of the module.

The model number identifies electrical rating. Electrical connections for each model vary.

SK-1200-AC, K-1205-AC, K-1210-AC,

K-1215-AC, K-1220-AC:

60 Hz

See Electrical Requirements section on page 11 of Product Requirements.

B.WIRING INFORMATION - 120 V, 60 HZ –

WALL TIMER VERSIONS

DANGER: Risk of electrical shock. Do not mount timer within reach of whirlpool user.

WARNING: Risk of electrical shock. To reduce the risk of electric shock, connect only to a properly grounded, grounding-type receptacle, protected by a Ground-FaultCircuit-Interrupter (GFCI). Do not remove the plug’s grounding pin. Do not use a grounding adapter.

Your Kohler Whirlpool bath is equipped with a cord and plug. All wiring of the pump and control has been completed at the factory. A licensed electrician must install a GFCI protected, 120 Volt, 15 Amp, grounded outlet. Your whirlpool may then be plugged into this outlet. No other load should be on this circuit. Locate the outlet within reach of the 36” cord.

Install wiring from the GFCI to the wall timer location. Use a switch box with adequate capacity.

Black (Line)

TIMER

White (Neutral)

Black

G

Black

F

C

 

I

PUMP

Green (Ground)

 

White White

Green

Green

106548-CA(9437)

20

Kohler Co., Kohler WI

Page 19 Page 21
Image 20
Page 19 Page 21
Contents 106548- CA Copyright E1994 Kohler Co Important Safety Instructions Table of Contents Introduction ROUGHING-IN K-1200-AC, K-1201-AC ROUGHING-IN K-1205-AC, K-1206-AC ROUGHING-IN K-1210-AC, K-1211-AC ROUGHING-IN K-1215-AC, K-1216-AC ROUGHING-IN K-1220-AC, K-1221-AC Installer Hazard Notification Product NoticesProduct Requirements Installation Requirements NEW or Replacement Installation RequirementsTools Required Materials Required Clearance RequirementsSite Requirements OLD Bath RemovalSubfloor Preparation Stud Pocket PreparationBefore Installing Unit TILING-IN Bead InstallationPartially Install Bath Drain Plumbing PreparationInstall Whirlpool Whirlpool SET-INSecure Whirlpool Height AdjustmentInstall Plumbing Identify Electrical Requirements Wiring Information 120 V, 60 HZ Excluding -J1 ModelsElectrical Connections AIR Actuator Versions Locate Field Wiring Compartment 120 V, 60 HZ -J1 Models only Field Wiring Diagram 120 V, 60 HZ -J1 Models onlyField Wiring Control BOX Compartment 230 V, 50 HZ Connect Control BOX 230 V, 50 HZElectrical Connections Wall Timer Versions Wiring Information 120 V, 60 HZ Wall Timer VersionsWater Test Whirlpool & Electronics Complete Finish WallOptional K-1507 Apron Installation Optional K-1515 Apron Installation Install Handles and Spout Complete InstallationCLEAN-UP After Installation Operating Sequence Confirm Proper OperationSTART-UP Whirlpool Symptoms Troubleshoot Whirlpool SystemProbable Causes Recommended ActionKohler Co., Kohler WI 106548-CA1093 106548-CA1093 Kohler Co., Kohler WI
Top Page Image Contents