Kohler K-1210-AC, K-1215-AC manual Confirm Proper Operation, START-UP Whirlpool, Operating Sequence

Page 25

20. CONFIRM PROPER OPERATION

A. START-UP WHIRLPOOL

Refer to Important Safety Instructions on page 2 before operating this whirlpool.

Please perform the following so that the owner may safely receive the benefits of whirlpool bathing.

1.Rotate jets so they are facing down toward basin.

2.Fill the whirlpool bath to a water level at least 2” above the top of the highest jet.

Water temperature in the whirlpool should not exceed 104_F (40_C).

Water Line

	Bath	2” Minimum
	Wall	2” Minimum
	Wall
		Jet Trim

B. OPERATING SEQUENCE

Refer to chart for proper operating sequence.

1.Turn on the whirlpool jets. Adjust each jet for optimum air/water mixture.

2.A built-in timer automatically stops the motor after 20 minutes of operation.

TO	METHOD		OBSERVE
Turn on whirl-
pool massage.
Add air to whirl-	Reduce	Add
pool action, rotate	Air	Add
pool action, rotate	Air	Air
flange counter-		Air
clockwise. To
reduce air, turn
clockwise.
Shut off whirlpool.
Restart whirlpool
after 20 minute
cycle is com-
plete.

Kohler Co., Kohler WI

25

106548-CA(9437)

Image 25

Contents 106548- CA Copyright E1994 Kohler Co Important Safety Instructions Table of Contents Introduction ROUGHING-IN K-1200-AC, K-1201-AC ROUGHING-IN K-1205-AC, K-1206-AC ROUGHING-IN K-1210-AC, K-1211-AC ROUGHING-IN K-1215-AC, K-1216-AC ROUGHING-IN K-1220-AC, K-1221-AC Product Notices Installer Hazard NotificationProduct Requirements NEW or Replacement Installation Requirements Installation RequirementsTools Required Materials Required Clearance RequirementsOLD Bath Removal Site RequirementsSubfloor Preparation Stud Pocket PreparationTILING-IN Bead Installation Before Installing UnitPartially Install Bath Drain Plumbing PreparationWhirlpool SET-IN Install WhirlpoolInstall Plumbing Height AdjustmentSecure Whirlpool Electrical Connections AIR Actuator Versions Wiring Information 120 V, 60 HZ Excluding -J1 ModelsIdentify Electrical Requirements Field Wiring Diagram 120 V, 60 HZ -J1 Models only Locate Field Wiring Compartment 120 V, 60 HZ -J1 Models onlyConnect Control BOX 230 V, 50 HZ Field Wiring Control BOX Compartment 230 V, 50 HZWiring Information 120 V, 60 HZ Wall Timer Versions Electrical Connections Wall Timer VersionsComplete Finish Wall Water Test Whirlpool & ElectronicsOptional K-1507 Apron Installation Optional K-1515 Apron Installation CLEAN-UP After Installation Complete InstallationInstall Handles and Spout START-UP Whirlpool Confirm Proper OperationOperating Sequence Troubleshoot Whirlpool System SymptomsProbable Causes Recommended ActionKohler Co., Kohler WI 106548-CA1093 106548-CA1093 Kohler Co., Kohler WI