Kohler K-1201-AC, K-1215-AC manual Installation Requirements, Tools Required Materials Required

Page 12

8. INSTALLATION REQUIREMENTS

A. TOOLS REQUIRED		B. MATERIALS REQUIRED
S	Conventional woodworking tools	S	Plumbers putty
S Arc pliers or 14” pipe wrench		S	Water-resistant sealer
S	Rule	S Wall coverings, as necessary
S	Level	S	RTV silicone sealant
S	Safety shoes	S	Four 1/4” x 1” lag screws

SSafety glasses

SSquare

SScrewdriver

SPliers

SUtility knife

C. CLEARANCE REQUIREMENTS

Check roughing-in and room dimensions in order to provide adequate available space for the bath unit.

D.NEW OR REPLACEMENT INSTALLATION REQUIREMENTS

This bath unit can be installed in new or existing bathrooms.

For new installations: Position plumbing according to roughing-in dimensions beginning on page 5. Cap supplies and check for leaks.

For replacement installations: Remove old bath, remove old wall material and remove old floor covering from area. Remove old plumbing which does not conform to roughing-in requirements.

106548-CA(9437)

12

Kohler Co., Kohler WI

Image 12

Contents 106548- CA Copyright E1994 Kohler Co Important Safety Instructions Table of Contents Introduction ROUGHING-IN K-1200-AC, K-1201-AC ROUGHING-IN K-1205-AC, K-1206-AC ROUGHING-IN K-1210-AC, K-1211-AC ROUGHING-IN K-1215-AC, K-1216-AC ROUGHING-IN K-1220-AC, K-1221-AC Installer Hazard Notification Product NoticesProduct Requirements Installation Requirements NEW or Replacement Installation RequirementsTools Required Materials Required Clearance RequirementsSite Requirements OLD Bath RemovalSubfloor Preparation Stud Pocket PreparationBefore Installing Unit TILING-IN Bead InstallationPartially Install Bath Drain Plumbing PreparationInstall Whirlpool Whirlpool SET-INHeight Adjustment Install PlumbingSecure Whirlpool Wiring Information 120 V, 60 HZ Excluding -J1 Models Electrical Connections AIR Actuator VersionsIdentify Electrical Requirements Locate Field Wiring Compartment 120 V, 60 HZ -J1 Models only Field Wiring Diagram 120 V, 60 HZ -J1 Models onlyField Wiring Control BOX Compartment 230 V, 50 HZ Connect Control BOX 230 V, 50 HZElectrical Connections Wall Timer Versions Wiring Information 120 V, 60 HZ Wall Timer VersionsWater Test Whirlpool & Electronics Complete Finish WallOptional K-1507 Apron Installation Optional K-1515 Apron Installation Complete Installation CLEAN-UP After InstallationInstall Handles and Spout Confirm Proper Operation START-UP WhirlpoolOperating Sequence Symptoms Troubleshoot Whirlpool SystemProbable Causes Recommended ActionKohler Co., Kohler WI 106548-CA1093 106548-CA1093 Kohler Co., Kohler WI