11. INSTALL WHIRLPOOL
A. WHIRLPOOL SET-IN
Choose one of the three recommended options below that is best for your particular installation as described in 1., 2., or 3. Follow the appropriate instructions.
If subfloor is not level, some shimming of the bath and pump will be necessary. See 11.B. for height adjustment.
1.Sunken Installation: Set unit into sunken installation. Make sure the bath/whirlpool is level and is resting on all blocks. Insert the tailpiece into the trap. Apply a bead of RTV sealant under rim of the bath unit.
2.Install Using Gypsum: Place a 2” thick layer of gypsum cement (such as
NOTE: Pump bracket must sit flat on the floor.
Insert tailpiece into trap. Make sure bath is level and resting on all supporting blocks.
3.Install Using 1 x 2 Strips: Set whirlpool in desired location and level. Nail 1 x 2 wood strips around blocks under the whirlpool to firmly hold it in position. It is not necessary to use strips on all blocks. They are only needed on blocks that are to the outside edges of your installation.
Insert tailpiece into trap. Make sure bath is level and resting on all supporting blocks.
Whirlpool
Blocks
Wood
Strips
Wood
Strips
Kohler Co., Kohler WI | 15 |