Installation
Please refer to safety instructions for important product safety information prior to installation or use of the product.
Follow the steps below to connect and install your P300 telephone.
A. Desk Mounting
1.Set the dial mode switch to T (tone) if you have touch tone service. Set the switch to P (pulse) if you have pulse (rotary) dialing.
2.Connect telephone line cord to telephone as shown in figure 3.
3.Connect handset cord to the telephone as shown below.
4.Lift the handset and listen for a dial tone.
5.Your P300 is ready to use.
$ |
1 | 1 |
4 | 4 |
Fig. 4 – Handset hook change
B. Wall Mounting
1.Pull the handset hook out and reverse its position so that the hook points up and will hold the handset when you hang up as shown in figure 4.
2.Insert the tabs of the phone base into the slots in the lower position of the base. Push in and down firmly until it snaps into place as shown in figure 5.
Fig. 3 – Connections and installation
10