Clarity P300 manual Troubleshooting, Hold Button Flash Button

Telephone Operations

FLASH

BOOST CLARITY POWER

FLASH

RINGER	BOOST
PITCH

Fig. 12 – Hold light	Fig. 13 – Redial button
I. Hold Button	K. Flash Button
To put the line on hold, simply press
	The flash feature is used to access
the HOLD button and return the
	special telephone functions and ser-
handset to its cradle. Notice the red
	vices available from your local phone
light HOLD indicator.When you
	company, such as call waiting, 3-way
pick up an extension phone on the
	calling and others. Press this button
same line, the P300 will disconnect.
	to activate the flash feature.
Putting the call on hold also mutes
the handset.
			FLASH
J. Last Number Redial
	RINGER	BOOST
				CLARITY
Button
	PITCH			POWER

The P300 phone remembers the last

number dialed from the phone (up to

32 digits). Lift the handset and simply Fig. 14 – Flash button press the REDIAL button to dial the

last number dialed.

Troubleshooting

If any problem should arise during use of your P300 phone, try the suggestions listed below. Should the difficulty persist, contact Clarity technical support at 800-426-3738 for assistance.

•No dial tone: Check all phone cord connections.

•No number dialed when memory button pressed: No number stored in that memory button. See "Programming The Photo Directory," p. 12.

•Call cannot be dialed, or is dialed slowly: See "Installation" section (p. 11) to reset the dial mode switch.

•No audible ring: Make sure the ringer is not set to "Off" position.

•No amplification: BOOST must be activated. See "Boost Button" section (p. 13).

•Static/Interference on line: Check cords and connections. Relocate phone to different phone jack.

• How to remove memory storage card and cover: Place thumb and	fore-
finger in center of card. Press fingers toward each other to pull card tabs	from
underneath casing.

14