
Installation
MANUAL
AUTO
Fig. 5 – Phone base installation for wall mounting
- OFF |
- ON |
BOOST |
Fig. 6 – Wall mounting installation
3.Using the short modular cord, mount the phone as shown in figure 6.
4.Set the dial mode switch to T (tone) if you have touch tone service. Set the switch to P (pulse) if you have pulse rotary) dialing.
5.Connect the handset cord to the telephone as shown in figure 3.
6.Lift the handset and listen for a dial tone.
7.Your P300 phone is ready for use.
C. Battery Installation
An optional 9 volt battery may be installed to brighten the visual ringer. To open battery compartment, use a pen to press down as indicated in figure 7A.
Insert 9V battery into compartment in base of phone
to access battery
compartment ![]()
![]()
Battery compartment
Press here to open battery compartment
Fig. 7A – Battery installation
11