Plantronics 610 manual do utilizador Bluetooth Pairing, Beep

6xx

”BEEP”

Bluetooth Pairing

Before using your headset for the first time, you must pair it with another Bluetooth device, such as a mobile phone. Make sure the headset is fully charged.

3.	On your phone, highlight and select
	“Look for Devices,” or equivalent, to
	activate the scan for the headset.
4.	When the phone display shows the scan
	results, select “6xx Plantronics”. The

POWERING ON AND OFF

1.Power on the headset by pressing and holding the call control button until the headset status indicator glows blue. If you are wearing the headset, you will hear a beep when the power turns on. The headset status indicator will flash blue every 6 seconds when the headset power is on.

NOTE When the headset is turned on, the headset status indicator will indicate the charge level of the headset.

Greater than 2/3 battery charge = 3 red flashes.

1/3 to 2/3 battery charge = 2 red flashes.

Less than 1/3 battery charge = 1 red flash.

2.Power off the headset by pressing the call control button for 6-8 seconds until the headset status indicator glows red or until you hear the beep. The headset status indicator remains unlit when the power is off.

Look in your Bluetooth device manual for the section that describes how to set up a Bluetooth wireless connection.

1.Move through the menu selections on your phone until the phone display shows “Look for Devices,” or equivalent, as a selection.

2.With your headset turned off, hold down the call control button until the headset status indicator briefly glows blue, then flashes red and blue. The headset is now in discovery mode and will stay that way for 30 seconds.

phone will continue to search for the

headset.

5. When the phone display asks for a

passkey, type “0000” and press Enter.

Your headset is now linked to your phone.