Eaton Electrical SC200 manual Applying AC Power, Configuring the Power System for Operation

Commissioning

Applying AC Power

1Switch on the AC supply.

2Check that each rectifier starts up and that the green Power On LED is on and both the red urgent and yellow non-urgent alarm LEDs are off. (If not consult the troubleshooting section in Chapter 7).

3Check that the SM45 supervisory module has powered up and that the green Power On LED on both the SM45 and the display module is on.

Depending on your configuration settings, the urgent and/or non-urgent alarm LED(s) may also be on.

4Check that all installed rectifiers are communicating and that the SM45 supervisory module has correctly registered all rectifiers, by viewing the individual rectifier currents in Main Display Mode. (See front panel menu structure on inside front cover or Viewing System Values in Chapter 5 for details.)

If no load is connected each rectifier will show 0 A.

Configuring the Power System for Operation

Each power system is supplied with a pre-loaded configuration file.

It is important that the settings of this configuration file are checked/verified and changed as required for site-specific conditions. In particular settings that may affect the performance and life expectancy of the battery must be checked and set according to the battery manufacturer’s recommendations.

Only those configuration parameters that are most likely to be changed on-site can be configured from the front panel. For entering and editing of all other configuration parameters (such as mapping of alarms to relays and setting up communications) a laptop computer and the latest version of DCTools is required. The latest version of DCTools can be downloaded from http://www.powerware.com/downloads

We recommend using DCTools for configuring your power system for operation.

Using the Front Panel Keypad

Scroll through the SM45’s Configuration Mode and change the configuration settings as required.

A list of all the configuration settings that can be changed from the front panel can be found on the inside back cover.

For details about changing configuration settings from the front panel, see Viewing and Editing Configuration Parameters in Chapter 5.

4-4	Copyright © 2005-2006 Eaton Corporation. All Rights Reserved.
	IPN 997-00012-41D December 2006