EnGenius Technologies 1X Regulatory Information, DuraFon FCC ID NI3-SN1302 IC 3616A-SN1302

Page 4

Regulatory Information

DuraFon 1X

FCC ID: NI3-SN1302

IC: 3616A-SN1302

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)this device may not cause harmful interference, and

2)this device must accept any interference received, including interference that may cause undesired operation.

1.The term “IC:” before the radio certification number only signifies that Industry of Canada technical specifications were met.

2.This telephone system complies with rules of the FCC Part 68 and Canadian IC/DOC CS-

03.On the bottom of the base station is a label that contains, among other information, the FCC Registration Number, Ringer Equivalence Number (REN) and the Universal Service Order Code, which is RJ-11C in the U.S. or CA-11A in Canada. Your telephone company may ask you for this information.

3.The REN is useful to determine the quantity of devices you may connect to your telephone line and still have all devices ring when your telephone number is called. In most, but not all, areas the sum of the REN’s of all devices connected to one line should not exceed 5.0. To be certain of the number of devices you may connect to your phone line, you should contact you local telephone company for the maximum REN in your area.

4.If your telephone equipment causes problems to the telephone network, the telephone company may ask you to disconnect your phone system from the line until the problem has been corrected. Consult with your local phone company for your rights if this happens.

5.Your telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the proper functioning of your telephone system. Consult with your local phone company for your rights if this happens.

6.This telephone system may not be used on coin service provided by the telephone company. Connection to party lines is subject to state tariffs.

7.This telephone system has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC Rules and RSS210 of the DOC Rules. These limits are designed to provide reasonable protection against harmful interference in a general public installation. Operations of these devices may still encounter interference from/to nearby TV’s, VCR’s, radios, computers, or other electronic devices. To minimize or prevent such interference, the telephone system should not be placed or operated near other electronic devices.

8.However, there is no guarantee that interference will not occur in a particular installation. If this telephone system does cause interference to other electronic devices, which can be determined by turning the system off and on, the user is encouraged to try to correct the interference by one or several of the following measures:

a.We recommend at least 20 feet between the system and other electronic devices.

b.Connect the base station to a power outlet on a circuit separate from that used by the device experiencing interference. Consult the dealer or an experienced electronic technician for help.

Notes:

In the event of any inconsistency between the English and French versions hereof, the English version shall prevail.

~7~

~8~

Image 4
Contents DuraFon General Safety Instructions Safety InstructionsProduct Safety Instructions Battery Safety Instructions Regulatory Information DuraFon FCC ID NI3-SN1302 IC 3616A-SN1302Handset Illustration Equipment ChecklistOLQH/& Basic Handset Features Additional Handset FeaturesTALK/ Speakerphone WAY/INTERCOM~13~ ~14~ Base Illustration Administrator FeaturesIRU Antenna Basic Base Station Features,Q Charger Features Handset and Charger InstallationMenu mode Basic OperationsOperation Modes Base Operation ModesPress END key to end the call Making an 2-Way/ Intercom CallIntercom/2-Way from Base to Handset Intercom/2-Way from Handset to Base CoverageBroadcasting from Base to Handset Broadcasting from Handset to BaseAdjusting Receiver Earpiece Voice Volume Receiving a Telephone CallPlacing a Call On Hold Receiving an Intercom CallBattery Recharge and Replacement Effective only for the current callDo Not Disturb Silent Ring Key GuardAdvanced Operations Handset RegistrationHandset Group Subscription Registration of Additional BaseCall Transfer Change System Settings by AdministratorCall Manager Phonebook Operations  LDOIURPGLVSOD\ Call barringText Messaging Programmable PBX OptionsMenu Operations Press 6 to change LCD display contrast Technical Specifications Press 9 to enable Name tagPress 0 to program PBX features that you use frequently Press 7 to change the LCD backlightIndex Page Effectuer un appel téléphonique Ajuster le volume de la voix du récepteur écouteurFaire une diffusion 102 Instructions de sécuritéInstructions générales de sécurité Instructions de sécurité du produit Instructions de sécurité pour la batterieInformation sur les règlements Liste de vérification de l’équipement Illustration du combinéCaractéristiques de base du combiné Caractéristiques additionnelles du combiné~59~ ~60~ Caractéristiques de l’administrateur Illustration de la base DUDFWpULVWLTXHVGHEDVHGHODVWDWLRQGHEDVHIllustration du chargeur GXFRPELQpDUDFWpULVWLTXHVGXFKDUJHXU  HQWHGHFKDUJHPHQWGHODEDWWHULHGHUHFKDQJHUHFKDQJHHVWHQFKDUJHPHQW YR\DQW/ / HVWXQYR\DQWOXPLQHXYHUWInstallation du combiné et du chargeur Comment démarrerMode Menu Opérations de baseModes d’opération Modes de fonctionnement de baseIIHFWXHUXQDSSHOWpOpSKRQLTXH HQVXLWHDSSX\HVXUODWRXFKH7$/.$&RPELQpV jDSSHOVGHFRPELQpV ¶LGHQWLILFDWLRQGXJURXSHIntercom/Bidirectionnel de la base au combiné « Broadcast »’identification ID de la Base 2 est Tous les combinés à l’intérieur de la couvertureAjuster le volume de la voix du récepteur écouteur RecompositionRecevoir un appel Intercom Recevoir un appel téléphoniqueNe pas déranger Sonnerie silencieuse Mettre un appel en attenteGarde-touches DiscrétionOpérations avancées Recharge et remplacement de la batterieEnregistrement du combiné Enregistrement de groupe de combinés Enregistrement d’une base supplémentaireTransfert d’appels Modifier les paramètres du système par administrateur Gestionnaire d’appelsVous pouvez ajuster le mode de composition Entre Tonalité et Impulsion. Le mode par défautDe la base à deux chiffres pour accéder au mode La tonalitéConfiguration » et une confirmation Terminé Opérations de l’annuaire téléphoniqueNumero ? Nom ? Capitale =Interdiction d’appels Messagerie texte Entrant Options d’autocommutateur privé programmablesVide Code de disposOpérations du menu Appuyez sur 8 pour modifier l’interdiction d’appels Appuyez sur 9 pour permettre le nom abrégéSpécifications techniques ~103~