UG060205_C410_RevA.qxd 6/15/05 8:03 PM Page 13
Getting Started
E
HANDSET BATTERY CHARGING
The battery in the handset must be fully charged for 12 hours before using the telephone for the first time.
1.Place the handset in the base. The CHARGE LED on the base will light green.
2.After the batteries are fully charged, check for dial tone by pressing TALK on the handset.
3.When the handset battery gets low, there will be 2 beeps every 30 seconds and the TALK button will flash. If the battery becomes low while you are on a call, you will be disconnected after about two (2) minutes. Terminate the call and recharge the battery.
To recharge battery pack, place the handset in the base. The unit can charge in the base unit either face up or face down. If charging in the face up position, the belt clip must be removed so the handset will connect with the charging contacts in the base.
1.Make sure the contact points are touching and the CHARGE LED is lit.
2.Be careful not to short battery with conducting materials such as rings, bracelets and keys.
BATTERY LIFE
Talk Time: 4 hours
Standby: 8 days without usage
Actual amounts will vary depending on the amplifier settings used.
Replace battery every two (2) years.
REPLACEMENT BATTERIES
The C410 uses a 3.6Volt 600mAHr NiMH Rechargeable battery. GP60AAAH3BMJZ, GPI International Ltd.
To Install Batteries
1.Remove battery cover.
2.Install battery.
3.Close battery cover.
4.Charge for 12 hours before first use.
BATTERY
CONNECTOR
BATTERY
BATTERY COMPARTMENT
PACK PLUG COVER
BATTERY
N G L I S H
13