TOPCOM TWINTALKER 1300
9LCD DISPLAY INFORMATION
a.Channel number
b.Speaker Volume
c.RX icon - Displayed when receiving a signal
d. TX icon - Displayed when transmitting a signal
e. Lock icon - Displayed when the keypad is locked. f. Battery charge level indicator
g. Scan icon - Displayed when scan mode is active
10 BATTERY CHARGE LEVEL/LOW BATTERY INDICATION
The BATTERY CHARGE LEVEL is indicated by the number of squares present inside the BATTERY icon on the LCD Screen.
SC
TX RX 
Battery Full Battery 2/3 charged Battery 1/3 charged Battery empty
When the BATTERY CHARGE LEVEL is low, the BATTERY icon will flash to indicate that the batteries need to be replaced or recharged.
Dispose of batteries at a designated battery disposal unit and not in the household waste. Do not
11 CHARGING RECHARGEABLE BATTERIES
The PMR can be used with 4 alcaline or rechargeable NiMh AAA batteries (no batteries included).
Only use the optional AC/DC ADAPTER (not included) with “AAA” rechargeable batteries (No batteries and adapter included). Do not try to charge this unit when regular “AAA” alkaline batteries are installed.
When using rechargeable batteries you can use the optional adapter to charge.
•Insert four (4) “AAA” rechargeable batteries (not included).
•Plug the small plug of the 7,5 V DC / 200 mA adapter into the SPK/MIC/CHG jack (3) and the
other end in the electrical socket.
• Make sure that the unit is switched off in order to charge the batteries properly. There is no charge indicator during charging at OFF mode.
NOTE: It takes approximately 7 to 10 hours to fully charge the batteries.
12 USING THE TWINTALKER 1300
12.1 TURNING THE UNIT ON/OFF
•To activate; press and hold 
. The unit will “beep” and the LCD Screen will display the current channel.
•To switch off; press and hold 
again. The unit will “beep” and the LCD Screen will turn blank.
6 | TOPCOM TWINTALKER 1300 |