Motorola 2000X quick start Flex PC Partner, What caused my application installation to fail?

Page 46

ÄIf the insufficient power is not corrected by changing the power source, the charger might be malfunctioning. Have the charger checked by an authorized service technician.

I just inserted a fresh battery, but it only lasted 2 days. Why?

When your PageWriter 2000X Two-Way Wireless Communications Center is set to two-way transmission but is not receiving Full Service (i.e., you are out of range), the pager continues to attempt to reestablish communication with the network. This acts as a continuous drain on the battery. Whenever you leave a two-way coverage zone, set the radio mode to One-way or Off to preserve the battery.

I haven’t used my pager in two months. When I place the unit in the charger, I get a flashing red light. Do I need a new battery?

Your battery is hyper-drained and it needs to be reconditioned.

1.Place the battery in the docking station. The light will blink red.

2.Let the battery sit overnight.

3.If the light is still flashing red in the morning, remove the battery and put it back into the charger.

4.Repeat procedure until the light goes green. If after three attempts the battery doesn’t charge to green, the battery can- not be reconditioned and must be replaced.

FLEX PC Partner

Why can’t I establish a connection between my pager and my PC via the infrared interface?

Check the following before re-attempting to establish a connection:

Make sure you have opened the FLEX PC Partner application

on your pager and selected to get the Connect Status screen.

Make sure your pager is placed properly in the docking station and that the RS232 cable and transformer are properly con- nected. For more information see “To connect the docking sta- tion to your computer:” on page 18.

Make sure the communications port on your PC is correctly set. For more information, see “To configure FLEX PC Part- ner:” on page 56.

84 PageWriter 2000X User’s Guide

What caused my application installation to fail?

The pager may be in a Low RAM status or you may be attempting to load an application that is close in size to the available RAM. Remove the pager from the charger. Reset the pager by turning it off then back on again. Run the installation program again.

Partner stopped working during a download and is unresponsive. What should I do?

The battery might be drained of power. Replace or recharge the battery, and restart the Partner download.

Commonly Asked Questions 85

Image 46
Contents @6881033B75@ Quick Start Guide Contents Welcome CustomizeOn the PageWriter 2000X Pager Using This ManualConventions Bold TextGetting Started Flip How Your PageWriter 2000X Pager WorksHome Screen Keyboard Standard Control KeysAlt Functions Alt-mode FunctionsTo recharge the battery without removing it from the pager Battery and ChargerShift-mode Functions To remove the battery for charging To replace the battery To recharge the battery outside of the pagerInfrared Port Holster System SetupTurning On and Off Your PageWriter 2000X Pager About PageWriter PLEASE! Carefully read ALL the instructions firstConfiguring Your PageWriter 2000X Pager To set the transmission modeSetting the Date and Time Assigning Alert ModesAssigning Alert Types AddressesEntering Addresses To edit an individual address To add a groupEditing Addresses To change the name of a groupDeleting Addresses WriteWriting Messages Attaching Message Replies Importing MessagesAdding Quick Text Saving Your Message to the Drafts InboxFiling a Message Draft Scheduling a Delayed SendEntering a One-Time Address Reading Incoming Messages Setting a Reminder Message AlarmRead Sending ResponsesDeleting Messages Forwarding MessagesFiling Messages Managing the Message AreaTo rename a personal inbox InboxesTo create a personal inbox To assign routing rulesTo set the alert type for an inbox To clean up an inboxTo assign a cleanup schedule to an inbox To delete a personal inboxOutbox Trashcan CustomizeViewing System Status Setting Up Internet Fax Service Enabling and Disabling Alerts and AlarmsCustomizing the User Interface Customizing Message Features Quiet TimeTo set an alarm To clean up all inboxesSetting the Alarm Clock Maintaining Inboxes and ApplicationsFlex PC Partner Using the PC Partner Shell Configuring Flex PC PartnerTo configure Flex PC Partner To open the Flex PC Partner ShellTransferring Address Book Information To determine a partlets versionManaging Your Address Book Address BookTo save an open Address Book file on your PC Managing Address Book FilesTo create an Address Book file on your PC To save an open Address Book file under a new nameTo import Address Books from other PC-based applications To open an Address Book file on your PCTo merge two Address Book files on your PC To delete an Address Book file from your PCManaging Addresses of Groups To add an individual to the Address Book on your PCTo delete an individual from the Address Book on your PC To add a group to the Address Book on your PCTo delete a group from the Address Book on your PC To add addresses to a group in the Address Book on your PCPrinting Address Book Information Managing Your Messages Installing and Removing Applications Backing-up and Restoring InformationUninstalling Flex PC Partner To copy data from your pager to your PC for backupTo restore data to your pager from your PC Checking Memory Usage on Your PageWriterProper Care and Cleaning Memory Management SystemGeneral Safety Instructions Patent InformationPageWriter 2000X Pager Specifications Commonly Asked QuestionsMy pager is acting funny. What’s wrong? Why don’t I receive messages?Why don’t I get alerted for incoming messages? MessagingWhy are my incoming messages placed in the wrong inbox? Why do I keep getting reminder alerts?Why does my pager keep alerting me to the same message? Why does the sending of my messages fail?What caused my application installation to fail? Flex PC PartnerSee also alarms unread message IndexMPSHELL.EXE PIN PageWriter 2000X User’s Guide
Related manuals
Manual 100 pages 51.52 Kb