Heat Controller DMC36CA-1 Function of Remote Control, Wireless LCD Remote Control, Nd F Button

Function of Remote Control

Function of Remote Control

1.Wireless LCD Remote Control

Signal transmitter

5			1
6
			3
4
2			10
		CANCEL
			9
7	OFF	SET
ON			12
11		AUTO CLEAN
8			17
		° C/° F	18
13
			14
15
			16

Flip-up door (opened)

Operation Mode

Cooling Operation

Auto Operation

Healthy Dehumidification Operation

1. START/STOP BUTTON

Operation starts when this button is pressed and stops when the button is pressed again.

2. OPERATION MODE SELECTION BUTTON Used to select the operation mode.

3.ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature.

4.INDOOR FAN SPEED SELECTOR Used to select fan speed in four steps

low, medium and high.

5. JET COOL

Used to start or stop the speed cooling.(speed cooling operates super high fan speed in cooling mode.)

6. AUTO SWING BUTTON

Used to stop or start louver movement and set the desired up/down airflow direction.

7.ON/OFF TIMER BUTTONS

Used to set the time of starting and stopping opera- tion.

8.TIME SETTING BUTTONS Used to adjust the time.

9.TIMER SET/CANCEL BUTTON

Used to set the timer when the desired time is obtained and to cancel the Timer operation.

10.SLEEP MODE AUTO BUTTON

Used to set Sleep Mode Auto operation.

11.AIR CIRCULATION BUTTON

Used to circulate the room air without cooling.

12.ROOM TEMPERATURE CHECKING BUTTON Used to check the room temperature.

13.PLASMA AIR CLEAN BUTTON

Used to start or stop the plasma-purification func- tion.

14.HORIZONTAL AIRFLOW DIRECTION CONTROL BUTTON (OPTIONAL)

Used to set the desired horizontal airflow direction.

15.RESET BUTTON

Used prior to resetting time.

16.2nd F Button

Used prior to using modes printed in blue at the bot- tom of buttons.

17.AUTO CLEAN (OPTIONAL) Used to set Auto Clean mode.

18.°C/°F SWITCH BUTTON

Used to switch temperature reading from Centigrade to Fahrenheit.

❈The wireless remote controller do not operate the swirl mode.

Service Manual 11