Philips AZ2725 manual Troubleshooting, Problem Possible Cause Remedy

English

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to solve a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty.

PROBLEM		POSSIBLE CAUSE	REMEDY
Set does not react to operation	–	Electrostatic discharge.	• Switch off the set, disconnect
of any button.			the power plug, then reconnect
			after a few seconds.
Display does not function	–	Electrostatic discharge.	• Switch off the set, disconnect
properly.			the power plug, then reconnect
			after a few seconds.
	– Set runs on batteries.		• Switch to AC power.
No sound.	– VOLUME is not adjusted.		• Adjust the VOLUME.
	– Headphones are connected.		• Disconnect headphones.
	–	Batteries are dead.	• Insert fresh batteries.
	–	Batteries are incorrectly	• Insert the batteries correctly.
		inserted.
	– Power cord is not securely		• Connect the power cord
		connected.	properly.
Bad sound.	– Unsuitable speakers are used.		• Use supplied speakers.
	–	Batteries are dead.	• Replace batteries.
No sound on left or right side.	– Speaker wrongly connected.		• Connect speaker properly.
Reversed left and right sound.	– Speakers are wrongly		• Connect speakers properly, L to
		connected.	left, R to right.
Severe radio hum or noise.	–	Set too close to TV, VCR or	• Increase the distance.
		computer.
Poor radio reception.	– Weak radio signal.		• FM: aim and extend the
			external antenna for best
			reception;
			• AM: rotate the entire set.
Poor cassette sound quality.	– Dust and dirt on the heads,		• Clean the heads, etc. See
		capstan or pressure roller.	Maintenance.
Recording does not work.	– Cassette tab(s) may be broken		• Put a piece of cellophane tape
		out.	over the missing tab space.
CD playback does not work.	–	CD is badly scratched or dirty.	• Replace or clean the CD. See
			Maintenance.
	– No CD inserted.		• Insert CD.
	– CD inserted upside down.		• Insert CD with printed side
			facing up.
	–	CD player lens is steamed up.	• Wait until lens is clear.
The CD skips tracks.	– CD is damaged or dirty.		• Replace or clean the CD.
	– PROGRAM/SHUFFLE is active.		• Switch off the
			PROGRAM/SHUFFLE function.

16