Names and Functions of Parts, Front panel

NAMES AND FUNCTIONS OF PARTS

– Front panel –

1
OPERATE	2
OPERATE

Mini	MENU	DISP	RESET	PROFESSIONAL	A.DUB		REC	PLAY	PAUSE
				PROFESSIONAL
	SEARCH–	SET	SEARCH+							3
					EJECT		REW	STOP	FF	3
MIC	HOLD	BLANK	CUE UP
	HOLD	BLANK	CUE UP
	PHONES	REC LEVEL					AUDIO	INPUT	REMOTE
					COUNTER MONITOR OUTPUT SELECT				REMOTE
					CTL	L	CH-1/2	DV
					TC	MIX	MIX	LINE
		CH-1/3	CH-2/4	BR-DV6000	UB	R	CH-3/4	Y/C	LOCAL
								(CPN)	LOCAL

1Cassette loading slot/LED

•For loading a cassette into or unloading it from the slot.

Insert a standard DV cassette or a mini DV cassette. (☞ Page 38)

•When BR-DV6000 is in the OPERATE OFF state and a cassette is loaded, it changes to the OPERATE ON state.

•With a cassette loaded, the LED lights up in green.

When a cassette is being loaded or ejected, the LED flashes.

2[OPERATE] button/LED

•Press this button to turn on the power and BR-DV6000 becomes ready for operation. (Operate ON)

Press this button again when BR-DV6000 is already on to turn off the power.

(Operate OFF)

•OPERATE LED lights up as follows.

Operate ON	: the green LED lights up
Operate OFF : the red LED lights up
VCR error	: the red LED blinks

Memo

●If DC IN MODE in the SYSTEM MENU screen is set to “OPE ON” or the Timer Switch is set to “REC” or “PLAY” and power is supplied to the DC IN terminal located on the rear panel, BR-DV6000 goes into the OPERATE ON state even if this button is not pressed.

●Even after the power is turned off with this button, BR-DV6000 is live with a small amount of electricity.

Therefore, if BR-DV6000 is not to be used for a long period of time, please remove the AC adapter to save energy.

3Operation buttons

[A. DUB] Audio dubbing button/LED

•Press this button for audio dubbing (after-re- cording).

For audio dubbing, set AUDIO MODE in the AUDIO MENU screen to “32K”.

The sound produced by the MIC terminal # or the AUDIO IN terminal is recorded on chan- nels CH3 and CH4.

•During audio dubbing, the red A. DUB LED lights up.

•If the INPUT SELECT switch is set to DV,

audio dubbing cannot be performed. (☞ Page 44 “Audio Dubbing”)

[REC] button/LED

•Hold down this button and press the PLAY button to start recording. During recording, the red LED lights up.

•Hold down this button and press the PAUSE button to pause recording.

•If this button is pressed during recording, an index signal is recorded on the tape (when INDEX WRITE in the SYSTEM MENU screen is set to ON).

•When this button is pressed in the STOP mode, the time code generator value can be checked while the button is being held down. If TC DUPLICATE Menu is set to AUTO or NON DROP, the time code, date and time of the DV input can be checked.

•If this button is pressed during playback, the input signal can be checked while the button is held down. (EE check)

EE check is not available for DV signal input.