JVC BR-DV6000U instruction manual Others,  Alarm display Displayed regardless of the Display mode

OTHERS – Warning display –

When an error occurs, BR-DV6000 automatically self-diagnoses the cause and displays an error- coded warning message on the monitor.

If BR-DV6000 is not in good order, or if an operation error has occurred, an alarm display will be shown on the monitor or the LCD.

Warning display

3 2 K C H Ð 1 / 2			S P 0 0 0 m i n
	W A R N I N G		7 0 0 1
	D R U M MO T O R		F A I L U R E
0 3 / 0 4 / 0 3			S T A N D B Y - O F F
1 1 : 2 0 : 0 0		T C R	0 2 : 0 0 : 0 0 : 0 0

Alarm display

3 2 K C H Ð 1 / 2 S P 0 0 0 m i n

H E A D C L E A N I N G R E Q U I R E D !

0 3 / 0 4 / 0 3	S T A N D B Y - O F F
1 1 : 2 0 : 0 0	T C R 0 2 : 0 0 : 0 0 : 0 0

Alarm display (Displayed regardless of the DISPLAY mode)

Display	Status	Action
LOW VOLTAGE	The DC power voltage is low.	Check the power voltage.
	BR-DV6000 will eventually go into the OPER-
	ATE OFF mode if operation is continued.
HEAD	The video head is dirty. (This message is dis-	Clean it with a JVC head-clean-
CLEANING	played when the DISPLAY mode is ON or	ing tape. (☞ Page 8)
REQUIRED!	AUTO.) If the head is clogged, it will be detected	If the message persists despite
	and the alarm message will be displayed in the	cleaning, it could be due to bad
	PLAYBACK mode.The display disappears when	recording condition, defective
	the cassette is ejected or the head gets cleared	tape or head lifespan.
	of clog.
	The message will also disappear when the head
	cleaning tape is loaded.
OVER	The internal temperature of BR-DV6000 has ex-	Disconnect the power and place
HEATING!	ceeded the stated value.	BR-DV6000 in a cool place. If
		this message is displayed
		again, the unit may have been
		damaged. In such a case, con-
		sult your JVC authorized
		dealer.
UNPLUG MAIN	This is a system error that occurs when the power	Unplug the power cord from the
POWER, PLUG	is turned on. The OPERATE indicator on BR-	power outlet and wait for some
BACK IN	DV6000 blinks in green. The unit will not accept	time before plugging it back in.
AFTER A	any operation commands.
WHILE

¥ For alarm displays resulting from operation errors, Refer to page 24.

97