Connecting to a monitor TV, Digital output | JVC BR-DV6000U instruction

●Connecting to a monitor TV

A monitor TV can be connected to the AUDIO MONITOR OUT terminal.

The sound output from the AUDIO MONITOR OUT terminal is monaural.

•The volume is adjusted through the monitor TV.

•The output channel can be selected with the AUDIO MONITOR switch on the front panel (Refer to the following table).

AUDIO MONITOR switches and output channels of AUDIO OUTPUT/PHONES

In the following cases, the output channels from the AUDIO MONITOR OUTPUT/PHONES termi- nal vary according to the setting of the AUDIO MONITOR switch and the AUDIO OUTPUT switch. The table below shows the channels.

•During playback of tapes recorded in the 32kHz audio mode.

•During audio dubbing.

•In the EE mode of DV input in the 32 kHz audio mode.

AUDIO switch		MONITOR OUT/
MONITOR	OUTPUT	PHONES terminal
MONITOR	OUTPUT
	CH1/2	CH1
L	MIX	CH1/3
	CH3/4	CH3
	CH1/2	CH1/2
MIX	MIX	CH1/2/3/4
	CH3/4	CH3/4
	CH1/2	CH2
R	MIX	CH2/4
	CH3/4	CH4

•In the 48kHz audio mode or during normal recording, it outputs to CH1/2 channel (the OUTPUT switch listed in the above table shows the setting of CH1/2).

•When MIX is selected, the PHONES termi- nal outputs stereo sound.

●Digital output

IEEE1394-compliant digital signals are output from the DV IN/OUT terminal.

Input signal

● Analog signal

CH 1/3 AUDIO IN terminal. (RCA2)

There are analog input terminals for 2 chan- nels. Recording cannot be performed to 4 chan- nels at the same time. Sound from each termi- nal is usually recorded to CH1 and CH2.

To record to CH 3 and CH 4, set AUDIO MODE

of the AUDIO Menu screen to 32 k and record it in the audio-dubbing mode. (☞ Page 44)

● Microphone input terminal

This terminal is for connecting to a monaural microphone. The same sound is recorded on the 2 channels.

Memo

●To record sound on the AUDIO IN terminal and MIC terminal, set the INPUT SELECT switch on the front panel to “LINE” or “Y/C (CPN)”.

●If the AUDIO IN terminal and MIC terminal are used at the same time, the MIC terminal precedes.

●Digital input

IEEE1394-compliant digital signals are input into the DV IN/OUT terminal.

•To enable audio input into this terminal, set the INPUT SELECT switch to DV.

•The AUDIO MODE (48 K or 32 K) will be one of input signals.

•During digital signal input, the recording level cannot be adjusted.

Memo

●An input/output board (sold separately) of the XLR connector can be installed in the optional slot.

SA-X61U AUDIO XLR IN board

SA-X62U AUDIO XLR OUT board These boards cannot be installed at the same time.

●For BR-DV600 player, when the mode is changed from STILL to PLAY, sound will be muted for a while shortly after the audio out- put. Thereafter, it will resume as per normal. (This does not occur with BR-DV600A.)