JVC BR-DV6000U Connecting the AC adapter, Connect the supplied AC adaptor to BR-DV6000

CONNECTION – Connecting the AC adapter –

Connect the supplied AC adaptor to BR-DV6000.

Screw

Supplied AC adaptor Clamp

Supplied power cord

DC cord

OPERATE indicator

				OPERATE	OPERATE button
ONAL	A.DUB		REC	PLAY	PAUSE
	EJECT		REW	STOP	FF
			AUDIO	INPUT	REMOTE
	COUNTER MONITOR OUTPUT SELECT
	CTL	L	CH-1/2	DV
	TC	MIX	MIX	LINE
DV6000	UB	R	CH-3/4	Y/C	LOCAL
				(CPN)

Memo

●Even in the OPERATE OFF mode, a small amount of electricity will still flow into the unit.

●When the unit is in the OPERATE OFF mode, no operation can be performed except that of the OPERATE buttons and cassette load- ing/ejecting.

LINE	VIDEO	COMPONENT			REMOTE2
Y/C
IN		R-Y	B-Y	IN
		Y
				OUT	AUDIO
				CH 1/3		CH 2/4
OUT						IN
						OUT
MONITOR		IN		OUT
OUT		SYNC IN	TIME CODE
			IN	OUT
				OFF
				REC	PLAY
SIGNAL		DV	SERIAL	TIMER		MONITOR
	DC12V	IN/OUT				OUT	REMOTE1
GND			REMOTE

DC IN terminal

TIMER switch

Before connecting the AC adaptor, en- sure that the TIMER switch is set to “OFF”. (Refer to “Notes” below.)

1. Connect the DC cord of the AC adapter to the DC IN terminal of BR-DV6000.

2. To prevent accidental disconnection of the DC cord, fasten the DC cord with a clamp.

1Remove the screw and the clamp shown in the above figure.

2Insert the DC cord into the clamp and fasten the clamp unto the unit.

3.Connect the supplied power cord to the AC IN terminal of the AC adapter.

4.Connect the power cord to the power outlet.

•BR-DV6000 is turned on and the OPERATE indicator lights up in red.

(OPERATE OFF mode)

•If DC IN MODE of the SYSTEM (2/2) Menu screen is set to “OPE ON”, the OPERATE in- dicator will light up in green.

(OPERATE ON mode)

Notes

LOW VOLTAGE

Alarm message

•Supply power to BR-DV6000 using the supplied AC adapter. Do not use other power sources.

•Do not unplug the DC cord and/or the power cord during recording or playback.

•If the supply voltage is low, an alarm display of “LOW VOLTAGE” is shown.

•If the TIMER switch is set to REC or PLAY, recording or playback begins when power is supplied to the DC IN terminal.

When the AC adapter is connected, ensure in particular that the TIMER switch is not set to REC.

Set the TIMER switch to REC or PLAY only when an external timer function is used.

35