JVC BR-DV6000U Optional devices,  RS-232C interface board SA-K46U  XLR in board SA-X61U

OTHERS – Optional devices –

LINE	VIDEO	COMPONENT			REMOTE2
Y/C
IN		R-Y	B-Y	IN
		Y
				OUT	AUDIO
				CH 1/3		CH 2/4
OUT						IN
						OUT
MONITOR		IN		OUT
OUT			TIME CODE
		SYNC IN
			IN	OUT
				OFF
				REC	PLAY
SIGNAL		DV	SERIAL	TIMER		MONITOR
	DC12V	IN/OUT				OUT	REMOTE1
GND			REMOTE

C

B

C

A

Memo

Install an optional board, SA-DV6000, SA- X61U, or SA-X62U to B as shown in the dia- gram above.

 RS-232C interface board: SA-K46U  XLR IN board: SA-X61U

This is an interface board for controlling BR- DV6000 with the RS-232C interface. Connect it to BR-DV6000 with the RS-232C cable. Use a reverse-type cable.

¥Replace it with the RS-422A REMOTE (9- PIN) terminal of A . (☞ Page 102)

¥To control BR-DV6000 with RS-232C, set REMOTE SEL 232 in the REMOTE (1/2). Menu screen to ÒONÓ.

¥Details of the command: (☞ Page 84)

This is an audio input board with two XLR ter- minals.

¥Connect it to B .

¥To enable audio input from the terminals, set

AUDIO INPUT SEL in the AUDIO Menu screen to XLR. (☞ Page 78)

XLR OUT board: SA-X62U

This is an audio output board with two XLR ter- minals.

¥Connect it to B .

Network board: SA-DV6000

This network board can be used to record streaming data of video and sound of BR- DV6000 on to CF card, and to transmit stream- ing data to the PC via a LAN card.

¥Connect it to B .

¥To control BR-DV6000 with SA-DV6000, set REMOTE SEL NET in the REMOTE (1/2) Menu screen to ON or LOC+REM.

¥With the SA-DV6000 installed, the network- related menus will be added.

For details, refer to the userÕs guide of SA- DV6000.

Installing SA-X61U or SA-X62U

1.Remove the slot cover by removing the two C screws, which are securing the cover.

2.Insert SA-X61U or SA-X62U into BR-DV6000.

3.Fix SA-X61U or SA-X62U to BR-DV6000 with the two C screws, removed in 1.

Note

Contact your JVC authorized service agent before installing the above optional boards.

101