JVC BR-DV6000U Connection, Connecting video signals,
Output signal,
Input signal, Sync

CONNECTION			– Connecting video signals –
Video output, e.g., VCR			Synchronization signal generator
	Input		BB signal
Composite		DV
Y/C	Component
LINE	VIDEOCOMPONENT		REMOTE2
Y/C
IN	R-Y B-Y	IN
	Y
		OUT	AUDIO
		CH 1/3 CH 2/4

OUT					IN		SYNC IN
					OUT
MONITOR		IN		OUT
OUT		SYNC IN	TIME CODE
		IN		OUT
				OFF
				REC	PLAY
SIGNAL		DV	SERIAL	TIMER	MONITOR
	DC12V	IN/OUT	REMOTE		OUT	REMOTE1
GND							Monitor
Y/C		DV			MONITOR OUT (Composite)

Composite Component

Output

Video output, e.g., VCR

Output signal

When BR-DV6000 enters the STOP, REC or EDIT mode, the input signal (E-E image) is out- put. In the PLAYBACK mode (including the play- back of the pre-roll part during editing), play- back images are output.

However, in the edit mode with analog input, signals cannot be output to the DV OUT termi- nal properly.

●Analog signal

•LINE OUT terminal (BNC): composite signal.

•Y/C OUT terminal (4-PIN): YC separate sig- nal.

When a wide screen ID signal exists in the video signal, the ID signal is output.

•COMPONENT OUT terminal (BNC3): Component (Y/B-Y/R-Y) signals are output. The output level is of ß cam (HIGH).

●Digital signal

•DV IN/OUT terminal: it outputs IEEE1394- compliant digital video signals.

When a wide screen ID signal exists in the video signal, the ID signal is output.

●Connection with a monitor TV

A monitor TV can be connected to the MONI- TOR OUT terminal. Besides the composite video signals, it also displays the on-screen dis- play for status or menu screen.

Input signal

The input video signal is selected with the IN- PUT SELECT switch on the front panel. Set VIDEO INPUT SEL in the VIDEO Menu screen to select YC input or component input.

●Analog signal

•LINE IN terminal (BNC): composite signal

•Y/C IN terminal (4-PIN): YC separate signal When a wide screen ID signal is being input, the ID signal is recorded.

•COMPONENT IN terminal (BNC3): The component (Y/B-Y/R-Y) signal. The output level is of ß cam (HIGH).

●Digital signal

•DV IN/OUT terminal : IEEE1394-compliant digital video signals are input.

When a wide screen ID signal is being input, the ID signal is recorded.

Set PB/DV IN in the SYSTEM (2/2) Menu screen according to the signal format to be input to the DV terminal. (NTSC or PAL).

Memo

Whether or not to enable SET UP for analog I/O signals of signals can be selected with SET UP in the VIDEO Menu screen (for NTSC only).

Memo

Set PB/DV IN in the SYSTEM (2/2) Menu screen according to the signal format of the tape to be played. (NTSC or PAL)

28