Getting Started
Rotary encoder
SOURCE/POWER
MUTE/SETUP
4
SOURCE/POWER
3 MUTE/SETUP
Turning Power On and Off
Press SOURCE/POWER to turn on the unit.
¥The unit can be turned on by pressing any other button except eject c and TITLE/.
Press and hold SOURCE/POWER for at least 2 seconds to turn off the unit.
¥ The first time power is turned on, the volume will start from level 12.
Detaching and Attaching the Front Panel
Detaching
1 Turn off the unit power.
2 Press (Release) at the lower left side until the front panel pops out.
3 Grasp the left side of the front panel and pull it out.
¥The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel). This is not a malfunction.
¥To protect the front panel, place it in the supplied carrying case.
Attaching
1 Insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit.
2 Push the left side of the front panel until it locks firmly into the main unit.
2 |
1 |
¥Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.
¥Attach the front panel carefully, holding the sides of the front panel to avoid pushing buttons by mistake.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first time, after changing the car battery, etc.
1 Turn off the unit power.
2 Remove the detachable front panel.
3 Press RESET with a ballpoint pen or similar pointed object.
1
RESET switch
Adjusting Volume
Turn the Rotary encoder
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume level by 20 dB.
Press MUTE/SETUP to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE/SETUP again will bring the audio back to its previous level.