Campbell Hausfeld WL6700 Series Installation, Location, Wheel Lock/Foot Brake, Engaged

Page 11

WL6700 Series

Installation

Location

When assembled, the tank must sit level to allow the tank to drain properly.

It is extremely important to install the compressor in a clean, well ventilated area where the surrounding air temperature will not be more than 100°F.

A minimum clearance of 18 inches between the compressor and a wall is required because objects could obstruct air flow.

Do not locate the compressor air inlet near steam, paint spray, sandblast areas or any other source of contamination. This debris will damage the motor.

Wheel Lock/Foot Brake

To move the compressor, use your foot to lift the foot brake lever to disengage the brake.

Once the compressor is at the desire location, use your foot to push down on the foot brake lever to engage the brake.

Electrical Installation

All wiring and electrical connections should be performed by a qualified electrician. Installation must be in accordance with local codes and

national electrical codes.

Never use an extension cord with this product. Use additional

 

air hose instead of an extension cord to avoid power loss and

STOP!

permanent motor damage.

 

Grounding Instructions

 

1.This product is for use on a nominal 120 volt circuit and has a grounding plug that looks like the plug illustrated in Figure 12. Only connect the product to an outlet having the same configuration as the plug. Do not use an adapter with this product. In the event of an electrical short circuit, grounding reduces risk of electrical shock by providing an escape wire for electric current. This product is equipped with a cord having a grounding wire with an appropriate grounding plug. Plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances.

Improper use of grounding plug can result in a possible risk of electrical shock!

Do not use a grounding adapter with this product!

2.If repair or replacement of cord or plug is necessary, do not connect grounding wire to either flat blade terminal. The wire with insulation having an external surface that is green (with or without yellow stripes) is the grounding wire.

Never connect green (or green and yellow) wire to a live terminal.

3.Check with a qualified electrician or serviceman if grounding instructions are not completely understood, or if in doubt as to whether product is properly grounded. Do not modify plug provided; if it will not fit outlet, have proper outlet installed by a qualified electrician.

Disengaged

Engaged

Figure 11 - Wheel Lock/Foot Brake

Figure 12 - Grounding method

www.chpower.com 11

Image 11
Contents Française Page Fr-1 Español página Sp-1 Ultimate Portable Garage Air CompressorFor parts, product and service information Table of ContentsDescription SpecificationsCalifornia Proposition Important Safety Information Safety GuidelinesSafety Symbols Breathable Air WarningWork Area WL6700 Series Important Safety InformationPersonal Safety Electrical SafetyDo Not Discard Spraying PrecautionsService Air SourceRead & Follow All Instructions Do Not Discard Contents in the CartonWL6700 Series Unpacking Additional Items not IncludedGlossary Asme Safety ValveTool Recommendation for this Compressor Continuous Use Intermittent Use Short powerful bursts Air chiselsWL6700 Series GettingUnpackingTo Know Your Compressor Recommended Uses for this CompressorInflation Hose Assembly AssemblyTools Required for Assembly Handle AssemblyWheel Lock/Foot Brake WL6700 Series InstallationElectrical Installation LocationLubrication WiringOperation Moisture in compressed airWL6700 Series Operation End of Operation/Storage Rapid Inflation Technology RITTo Use Compressor For Inflation To Use Compressor For Air Tool UsageDrain Tank MaintenanceCleaning Torque Requirements Technical ServiceAir FIlter Thermal Overload ProtectorWL6700 Series Service Record Symptom Cause Solution Troubleshooting GuidePart Description Qty Replacement Parts List for Pump, Model WL390100Please provide following information Pressure Gauge, 1.5 in. Diameter What is not Covered Under this Warranty WarrantyEnglish Español página sp-1 ’ultime compresseur d’air de garage portableTable des Matières Fr-3 SpécificationsAvertissement D’Air Respirable Symboles de sécuritéDirectives de sécurité Importantes instructions de sécuritéSérie WL6700 Importantes instructions de sécurité Suite Conserver ces instructions Ne les jetez pas Fr-6 Précautions de pulvérisationSource d’air Conserver ces instructions Ne pas les jeter Fr-7 Série WL6700 DéballageContenu de la boîte Autres articles non inclusFr-8 GlossaireFr-9 Utilisations recommandées pour ce compresseurOutils non recommandés Série WL6700 Apprendre à connaître votre compresseurAssemblage du tuyau de gonflement AssemblageOutils requis pour l’assemblage Assemblage de poignéeDésengagé Installation électriqueSérie WL6700 EndroitFonctionnement Installation SuiteSérie WL6700 Fonctionnement Suite Fr-14 Pour utiliser le compresseur pour le gonflementPour utiliser le compresseur pour un outil pneumatique Conclusion du travail/entreposageFr-15 EntretienPurger le réservoir NettoyageProtecteur de surcharge thermique Service techniqueFiltre d’air GraissageFr-17 Modèle WL6701 État de serviceFr-18 Guide de dépannageFr-19 Liste de pièces de rechange pour la pompe, modèle WL390100Nécessaires de pièces de rechange Fr-20 Fr-21 Fr-22 Garantie LimitéeEnglish Française Page fr-1 El máximo compresor de aire portátil para el garajePor información sobre piezas, productos y servicios ÍndiceSp-3 DescripciónEspecificaciones Advertencia Sobre El Aire Respirable Importantes Instrucciones De Seguridad Medidas de SeguridadSímbolos de Seguridad Serie WL6700 Servicio Importantes Instrucciones De Seguridad ContinuaciónPrecauciones para Rociar Suministro de AireArtículos Qdicionales no Incluidos Serie WL6700 DesempaqueContenido de la Daja Sp-8 GlosarioHerramientas no recomendadas Herramientas de corte Serie WL6700 Conozca su CompresorUsos Recomendados para este Compresor Uso Intermitente Impulsos potentes de corta duraciónSp-10 Herramientas Necesarias para el EnsamblajeEnsamblaja del Mango Ensamblaja de la MangueraSerie WL6700 Instalación Funcionamiento Instalación ContinuaciónSerie WL6700 Funcionamiento Continuación Conclusión del Trabajo/Almacenaje Tecnología de Inflado Rápido Rapid Inflation Technology RITUso del Compressor para Inflar Uso del Compresor para Herramientas NeumáticaSp-15 MantenimientoDrene el Tanque LimpiezaTorque Requerido Filtro de AireLubricacion Protector TermicoSp-17 Modelo WL6701 Registro de ServicioSp-18 Tabla de Identificación de ProblemasCausa Solución Sp-19 WL390100Lista de Piezas de Repuesto para Bomba, Modelo Juegos de repuestosSp-20 Sp-21 Sp-22 Garantía LimitadaPage Notas