Porter-Cable A16759 instruction manual Before Starting, Before Each Start-Up, How to Stop

Page 14

How to Use Your Unit

How to Stop:

1.Set the On/Auto/Off lever to "OFF".

Before Starting

Break-in Procedure

Serious damage may result if the following break-in instructions are not closely followed.

This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced.

1.Make sure the On/Auto/Off lever is in the "OFF" position.

2.Check oil level in pump. See "Oil" paragraph in the "Maintenance" section for instructions.

3.Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manual.)

4.Open the drain valve fully (counter-clockwise) to permit air to escape and prevent air pressure build up in the air tank during the break-in period.

5.Move the On/Auto/Off lever to "ON/AUTO" position. The compressor will start.

6.Run the compressor for 20 minutes. Make sure the drain valve is open and there is minimal air pressure build-up in tank.

7.After 20 minutes, close the drain valve (clockwise). The air receiver will fill to "cut-out" pressure and the motor will stop.

The compressor is now ready for use.

Risk of bursting. Use a tire pressure gauge to check the tires pressure before each use and while inflating tires; see

the tire sidewall for the correct tire pressure.

NOTE: Air tanks, compressors and similar equipment used to inflate tires can fill small tires similar to these very rapidly. Adjust pressure regulator on air supply to no more than the rating of the tire pressure. Add air in small increments and frequently use the tire gauge to prevent over inflation.

Before Each Start-Up:

1.Place On/Auto/Off lever to "OFF".

2.Pull regulator knob out, turn counter-clockwise until it stops. Push knob in to lock in place.

3.Attach hose and accessories. NOTE: The hose or accessory will require a quick connect plug. To use remote console, see "How to Use Remote Console" paragraph in this section.

Too much air pressure causes a hazardous risk of bursting. Check the manufacturer’s maximum pressure

rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pressure rating.

A16759

14- ENG

Image 14
Contents Direct Drive Oil Lube Portable Air Compressor Death or serious injury Or moderate injury Safety Guidelines DefinitionsImportant Safety Instructions Death or serious injuryLocation away from compressor Spray area. An additional length of hoseExplosion May be required Attachments & Accessories To alter the factory set operating pressuresRepairs attempted by unqualified Your specific application Or attempt maintenance until unit hasTo human consumption Result in serious burnsFire, Inhalation, Damage to Vehicle Surfaces Glossary SpecificationsAccessories Duty CycleAssembly To Add Oil To PumpInstallation Location of the Air CompressorExtension Cords Voltage and Circuit ProtectionOperation On/Auto/Off Switch a Turn thisPressure Switch B The pressure Know Your Air Compressor Description of OperationCooling System not shown This Motor Thermal Overload Protector not shownBefore Each Start-Up How to StopBefore Starting Tire sidewall for the correct tire pressureHow to Start How to Use Remote ConsoleHow to transport unit Customer Responsibilities MaintenanceTo Check Safety Valve To Drain TankChecking OilAir Filter Inspection and Replacement MotorService and Adjustments To Replace or Clean Check ValveStorage Troubleshooting Pressure reading Problem Cause Correction Problem Cause Correction Limited Warranty Manual de Instrucciones Lesiones serias Definiciones DE Normas DE SeguridadLesiones serias Resultar en lesiones menores o Moderadas Instrucciones Importantes DE Seguridad Cómo prevenirloAdvertencia Riesgo de Explosión Qué puede occurrir Cómo prevenirlo31- SP A16759 Advertencia Riesgo de Quemaduras Qué puede occurrir Advertencia Riesgo de Caída Qué puede occurrir Advertencia Riesgo de Operación Lasegura Qué puede occurrirEspecificaciones GlosarioCiclo DE Servicio AccesoriosEnsamblado Agregado de aceite a la bombaEnchufe InstalaciónUbicación del compresor de aire Espiga de conexión a tierraCables de extensión eléctrica Protección del voltaje y del circuitoOperación Conozca su compresor de aireVálvula de drenaje I La válvula de drenaje Válvula aliviadora de presión M La válvula aliviadora deCómo detenerla Cómo utilizar su unidadAntes de poner en marcha Procedimiento para el asentamientoCómo utilizar la consola de control remoto Cómo poner en marchaCómo transportar la unidad Cómo drenar el tanque MantenimientoCómo verificar la válvula de seguridad Riesgo de su ruptura o explosiónVerifique AceiteCambio Ruptura del tanque de aireFiltro de Aire Inspección y reemplazo Servicio Y Ajustes Para reemplazar o limpiar la válvula de retenciónAlmacenaje Originando un riesgo de ruptura de sus paredesGuía DE Diagnóstico DE Problemas Se utiliza un A16759 50- SP 51- SP A16759 Garantía Limitada Responsabilidad DEL Comprador Original Usuario inicialManuel dinstructions Ou la mort Causer des blessures mineures ou Moyennes Mesures DE Sécurité DéfinitionsConsignes DE Sécurité Importantes Évité, peut causer des dommages à laConserver ces directives Avertissement Risque dexplosion ou dincendie PréventionAvertissement Risque déclatement Risque PréventionAvertissement Risque de projection dobjets Avertissement Risque de choc électriqueAvertissement Risque relié aux pièces mobiles Avertissement Risque par inhalationAvertissement Risque de brûlures Avertissement Risque dune utilisation dangereuse Avertissement Risque de chuteRisque Lexique Cycle DE ServiceAccessoires Modèle no C3551Assemblage Ajout dhuile à la pompeUtiliser UN ADAPTATEUR. Voir Emplacement du compresseur dairCourant TerreProtection contre la surtension et protection du circuit RallongesUtilisation Familiarisez-vous avec votre compresseur dairFiltre dadmission dair K Ce filtre a été conçu pour Robinet de vidange I Le robinet dePompe du compresseur dair non illustrée Soupape de retenue L Lorsque le compresseurAvant chaque mise en marche Arrêt de lappareilAvant le démarrage Procédures de rodageMise en marche Utilisation de la console à distanceTransport de lappareil Responsabilités du consommateur EntretienVérification de la soupape de sûreté Vidange du réservoirVidange HuileVérification Filtre à air Inspection et remplacement MoteurRemplacement ou nettoyage de la soupape Entretien ET RéglagesRangement Dépannage Elle doit être remplacée Le moteur ne Bruit de cliquetis 78- FR 79- FR A16759 Garantie Limitée Responsabilité DE Lacheteur Dorigine utilisateur initial