charger from position “A” to position “B” reduces the frequency of the discharge pulses. This has a minimal impact on the effectiveness of the charger.
Towards the end of the rapid charge cycle (STEADY RED indication), the battery voltage exceeds the normal operating voltage of the radio. The voltage returns to a normal level following the rapid charge mode or when the battery is removed from the charger.
If the radio is turned on while the charger is in rapid charge mode, the radio becomes temporarily inoperable. This condition can be cleared by removing the radio from the charger and turning the radio off and on again.
During the reconditioning process, the battery becomes fully dis- charged. As a result, the radio may not function during reconditioning mode.
In some cases, such as use near fluorescent lighting or electric motors, a slight hum may be noticed in the receiving radio. If this occurs, mov- ing the charger or repositioning the power cord should eliminate the hum.
When troubleshooting, always observe the charge indicator – Refer to Table 7 on page 9.
English
13