Black & Decker JS670V instruction manual Operation, Blade Install tion fig. a, To se the beve angl

OPERATION
WARNING: Before attempting any of the following operations, make sure that the tool is
switched off and unplugged and that the saw blade has stopped. Used saw blades can be
hot.
- Hold the saw blade (4) as shown, with teeth	A
Blade Install tion (fig. A)
facing forward.	4
- Push the saw blade locking lever (3)
downward.
- Insert the shank of the saw blade into the
blade holder as far as it will go.
- Release the lever.
- Check to ensure blade is secure before
cutting.	3

Adjusting the shoe plate for bevel cuts (fig. B)
WARNING: Never use the tool when the saw shoe is loose or removed.
The shoe plate can be set to a left or right bevel angle of up to 45°.
- Pull the shoe plate beveling lever (9) out	B
To se the beve angl :
away from the saw to unlock the shoe plate
(7) as shown in figure B.
- Slide the shoe plate (7) forward to release it
from the 0° positive stop position.
- The shoe canbe beveled to the left or to the
right and has detents at 15°, 30° and 45°
(figure C).
- Set the plate to the desired bevel angle.As
you set the shoe angle the amount of
degrees can be read through the bevel angle
window (8). Use a protractor to verify angle		8
accuracy.
- Push the shoe plate beveling lever (9) back
towards the saw to lock the shoe plate (7).
- Pull the shoe plate beveling lever (9) out
To reset the shoe plate for straight cuts:
away from the saw to unlock the shoe plate	7	9
(7) as shown in figure B.
- Rotate shoe plate to an angle of	C	6
approximately 0° and then pull shoe plate
backwards to engage the 0° positive stop.
- Push the shoe plate beveling lever (9) back
towards the saw to lock the shoe plate (7).

6