HINTS FOR OPTIMUM USE
SawingAs the sawlaminbladetescuts on the upward stroke, splintering may occur on the surface closest to the shoe plate.
- Use a
- Saw from the back surface of the workpiece.
- To minimize splintering, clamp a piece of scrap wood or hardboard to both sides of the workpiece and saw through this sandwich.
Sawing- Be awarem talthat sawing metal takes much more time than sawing wood. - Use a saw blade suitable for sawing metal.
- When cutting thin metal, clamp a piece of scrap wood to the back surface of the workpiece and cut through this sandwich.
- Spread a film of oil along the intended line of cut for easier operation and longer blade life. For cutting aluminum, kerosene is preferred.
filingsWARNING:will be hotFireandHazardmay cause.Do anotfireuse. vacuum adapter when cutting metal. Metal
|
| TROUBLESHOOTING |
|
Problem | Possible Cause | Possible Solution | |
• | Unit will not start. | • Cord not plugged in. | • Plug tool into a working |
|
| • Circuit fuse is blown. | outlet. |
|
| • Replace circuitfuse. | |
|
|
| (If the product repeatedly |
|
|
| causes the circuit fuse to |
|
|
| blow, discontinue use |
|
|
| immediately and have it |
|
|
| serviced at a Black & |
|
|
| Decker service center or |
|
| • Circuit breaker is tripped. | authorized servicer.) |
|
| • Reset circuit breaker. | |
|
|
| (If the product repeatedly |
|
|
| causes the circuit breaker |
|
|
| to trip, discontinue use |
|
|
| immediately and have it |
|
|
| serviced at a Black & |
|
|
| Decker service center or |
|
| • Cord or switch is damaged. | authorized servicer.) |
|
| • Have cord or switch | |
|
|
| replaced at Black & |
|
|
| Decker Service Center or |
• | Shoe plate is loose. | • Retaining screw loose. | Authorized Servicer. |
• Loosen the screw | |||
|
|
| closest to the blade on the |
|
|
| underside of the shoe |
|
|
| plate. |
|
|
| Tighten the screw farthest |
|
|
| from the blade by turning |
|
|
| counterclockwise |
|
|
| (left hand thread) |
|
|
| Reminder: The bevel lever |
|
|
| must be in the closed |
|
|
| position. Tighten the |
• | UV light will not come on.• Batteries weak. | screw closest to the blade. | |
Replace batteries. | |||
|
| • Batteries inserted incorrectly. | Reinsert batteries making |
|
|
| sure they match the (+) |
|
|
| and |
For assistance with your product, visit our websitefor the location of the service center nearest you or call thewwwBLACK.blackanddecker& DECKER help.comline at
11