Black & Decker JS670V instruction manual Using the UV light figure G & H, To use the UV light

Operating the UV Module (figure F, G & H) Installing- Pivot thetheUVbatteriesmodule door(figure(17)F)away from the jig saw by removing the screw (18)and

pulling the door forward.

- Insert three new 1.5 Volt AAAalkaline batteries (19), making sure to match the (+) and (-) terminals correctly.

- Close the UV module door and replace the screw.

Using the UV light (figure G & H)

The UV module projects a UV light which illuminates a highlighter line drawn on the surface of the workpiece.

To use the UV light:

- Mark your intended cutting line using the highlighter marking pen (15) as shown in figure G.

- Switch the UV light (14) on by pressing the button (13).

- To switch the UV light (14) off, press the button (13) again.

- Position the jig saw over the cutting line (19).

Viewing from directly above the jig saw,the line of cut will be illuminated (20) by the UV light (14) and can be easily followed.

F
18
17	19
G
	15

H
	13
	20
19	14
	20
	14

9