- To switch the tool on, press the variable speed switch (1). |
| |
Switching on and off |
| |
- For continuous operation, press the variable speed switch(1), press the | ||
(2) and release the variable speed switch. |
| |
- To switch the tool off, releasethe variable speed switch. To switch the tool off,when in | ||
continuous operation, press the variable speed switch once more and release it. | ||
Variable speed is controlled through the variable speed switch (1). Thetool speed | ||
Variable Sp | Control |
|
depends on how far you depress the switch. For best results, start your cut by gently | ||
squeezing the trigger (slow speed) and gradually speed up (squeeze triggermore) as you | ||
move through your cut. |
| |
To select the proper orbital action for thetype of material that you are cutting, followthe | ||
Setting the desired cutt ng mode (Smar S lect )(fig. D) |
| |
steps below: |
|
|
| D | |
Step 1 - Turn the dial (10) as shown infigure D to the appropriate | ||
icon. Refer to the chart on page 7 for descriptions of the 7 different | ||
positions. |
|
|
Step 2 - Insert the proper blade based on the chart mentioned |
| |
above. |
|
|
Step 3 - Perform the cut. |
|
NOTE: These settings are initial recommendations. Your application may work best with different settings. Test these positions on similar material prior to making finished cut and adjust selections for desired results.
10
Blade storage (fig.E)
toA bladethe sidestorageof thecompartmentsaw. (11) is
E
The blades slide in and out of the
compartmentClose. door securely before operatingCAUTION:saw.
4 11
8