Shindaiwa 4 Cycle Diesel Engine specifications Turn the fuel line valve lever to 『CLOSE』

②Loosen and remove the oil filter, using an oil filter wrench.

③Smear a little engine oil on the rubber gasket of a new filter.

④Screw the new filter into place and tighten it by hand until the gasket contact the seat. Then, give it additional 『1.1/4 Turn』to seat the filter, using an filter wrench.

⑤Supply oil and install the filler cap. <Caution>

z If an oil filter wrench is not available, contact our au- thorized distributor or our engineering section.

z Oil Filter Part No.: 119305-35151 (Yanmar)

11.3Cleaning/Changing Air Filter Element

Clean	Every 200 hours
Replace	Every 400 hours

①Unfasten clips in the cleaner cap and remove the air cleaner cap.

②Unscrew the wing bolt and remove the air filter ele- ment.

③Clean or replace the air filter element, and reinstall it in reverse order.

<Caution>

zClean more frequently, if used in dusty environment.

zAir Filter Element Part No. 121465-12510 (Yanmar)

„How to clean air filter element

<If the element has dried contaminants>

It may be cleaned by blowing compressed air from the inside. <If the element has carbon or oil>

It should be replaced to a new one.

OIL GAUGE (YELLOW)

OIL FILTER

GASKET

AIR CLEANER

SIDE DOOR

ELEMENTCLIP

WING BOLT

CLEANER

11.4 Cleaning/Changing Fuel Filter

Clean	Every 200 hours
Replace	Every 400 hours

FUEL LEVER

	CLOSE	RETAINING
		RING
①	Turn the fuel line valve lever to 『CLOSE』.	OPEN
②	Unscrew the retaining ring by turning counterclockwise, and	CUP
	remove the cup and fuel filter element.

③Discard any dust or water inside the cup, and clean the filter element by blowing compressed air. (or replace, if necessary) (When you replace the filter element, be sure to replace a o-ring

26