Shindaiwa 4 Cycle Diesel Engine specifications Introduction

Page 2

Introduction

Thank you for purchasing Shindaiwa Sound Proof Diesel Engine Generator/Welder.

zThis user manual was created to ensure the safe operation of this equipment. Therefore, the manufacturer of this equipment strongly recommends that the user follow the instructions herein, to avoid unnecessary accidents and repairs.

zPlease operate this equipment after thoroughly reviewing and understanding the contents of this manual.

zPlease attach this manual, if the equipment will be sub-leased.

zPlease store this manual near the equipment for easy reference.

■Following convention will be used throughout the manual to indicate the degree of cautions.

		Danger	Can cause severe injuries or death.

		Caution	Can cause minor injuries or damage to the equipment or other prop-
			erties.

<Caution>			Other types of caution

z Even some of the items noted in

Caution 』 may lead to severe injuries. Please read all

items and follow all the safety guidelines.

1

Image 2

Contents ＤＧＷ３１１ＤＭＤＧＷ３１１Ｌ Introduction Safety Guidelines Page DGW311DM DGW311L Specifications DGW311DM DGW311LUse PartsEquipment ECO Welding DGW311DM only Monitor Lamp Earth Leakage Breaker Earth Grounding Terminal Bonnet Grounding Grounding ROD Checking Engine Oil Slow-Down FeatureInitialization and Pre-check SAE10W/30 Checking Coolant/WaterLowest Ambient Temperature Mixture Ratio 30% 35% 45% Checking FuelOperation Initializing/Preparation Checking BatteryChecking Fuel, Engine Oil and Water Leakage Ishes ⑧ Keep the engine idle for about 5 minutesWelding Operation Selection Welding Cable „ Restart after stopping due to fuel shortageStopping Generator/Welder ECO Single Dual Welding Rod Φ2.0 φ4.0 Φ2.6 φ6.0 PolarityConnection Welding Cable Duty Cycle WeldingMaximum output from the terminals U, V, W is 10kVA 『DUAL 』35-280A45-310A φ2.0-φ6.0 380V 400V 415V 2.2 1-Phase Output Terminals 380V 400V 415VOutput Limitation Operation Simultaneous Use of Welding and Generating Checking and Maintenance Adjust Engine Valve Clearance Clean/Change Fuel FilterAdjust Tension V-Belt 50hrsRemove the cup and fuel filter element Turn the fuel line valve lever to 『CLOSE』Unscrew the retaining ring by turning counterclockwise, Long Term Storage Water or contaminants in fuel TroubleshootingInsufficient Fuel Excessive Welding ArcSlow-Down does not activate No AC outputAC Output is Weak Engine does not stop Stop Solenoid disorderEngine Wiring Diagram DGW311L DGW311DMGenerator Wiring Diagram DGW311L W220B DGW311L W380A DGW311L W400A DGW311L W415A Telephone 81-82-849-2220 FAX