Shindaiwa 4 Cycle Diesel Engine specifications 380V 400V 415V 2.2 1-Phase Output Terminals

Page 21

9-1.1.2 1-Phase 220V Output – Terminals (using the terminals only)

1-Phase 220V Output is available, using the 3-phase output terminals. Maximum output available for the one set of the terminals is 6kVA but the total output for the 3 sets is 8kVA, which please note.

9-1.1.3 1-Phase 110V Output – Receptacles & Terminals

1-Phase 110V Output is available through 2 receptacle sets and one terminal set.

Maximum output per one receptacle is 1.5kVA and one terminal set is 3kVA. The total output for the receptacles and the terminal set is 6kVA.

9-1.2 DGW311L-(W)380A, DGW311L-(W)400A, DGW311L-(W)415A 9-1.2.1 3-Phase Output – Terminals

Maximum output from the terminals (U, V, W) is 10kVA.

DGW311L

	-(W)380A	-(W)400A	-(W)415A
Output
voltage	380V	400V	415V

9-1.2.2 1-Phase Output – Terminals

1-Phase Output is available, using the 3-Phase output terminals. Maximum output available for the one set of the terminals is 6kVA but the total output for the 3 sets is 8kVA, which please note.

		DGW311L
	-(W)380A		-(W)400A	-(W)415A

Output
voltage	380V		400V	415V

20

Image 21

Contents ＤＧＷ３１１ＤＭＤＧＷ３１１Ｌ Introduction Safety Guidelines Page DGW311DM DGW311L DGW311DM DGW311L SpecificationsParts UseEquipment ECO Welding DGW311DM only Monitor Lamp Earth Leakage Breaker Earth Grounding Terminal Bonnet Grounding Grounding ROD Slow-Down Feature Initialization and Pre-checkChecking Engine Oil Checking Coolant/Water SAE10W/30Checking Fuel Lowest Ambient Temperature Mixture Ratio 30% 35% 45%Checking Battery Checking Fuel, Engine Oil and Water LeakageOperation Initializing/Preparation ⑧ Keep the engine idle for about 5 minutes Ishes„ Restart after stopping due to fuel shortage Stopping Generator/WelderWelding Operation Selection Welding Cable Polarity Connection Welding Cable ECO Single Dual Welding Rod Φ2.0 φ4.0 Φ2.6 φ6.0 Welding Duty Cycle『DUAL 』 35-280A45-310A φ2.0-φ6.0Maximum output from the terminals U, V, W is 10kVA 380V 400V 415V 380V 400V 415V 2.2 1-Phase Output TerminalsOutput Limitation Operation Simultaneous Use of Welding and Generating Checking and Maintenance Adjust Tension V-Belt Clean/Change Fuel FilterAdjust Engine Valve Clearance 50hrsTurn the fuel line valve lever to 『CLOSE』 Unscrew the retaining ring by turning counterclockwise,Remove the cup and fuel filter element Long Term Storage Insufficient Fuel TroubleshootingWater or contaminants in fuel Excessive Welding ArcAC Output is Weak No AC outputSlow-Down does not activate Engine does not stop Stop Solenoid disorderDGW311L DGW311DM Engine Wiring DiagramGenerator Wiring Diagram DGW311L W220B DGW311L W380A DGW311L W400A DGW311L W415A Telephone 81-82-849-2220 FAX