INSTALLING THE BELT HOOK
Always disconnect tool from air supply before making adjustments or before attempting any part assembly or disassembly.
Always remove the belt hook from the tool when selecting Contact Trip Mode.
1.Assure that the sequential trip mode is selected
2.Depress the belt hook release button on the belt hook body
3.Slide the belt hook into the belt hook attachment slot
4.Release the belt hook release button and check to ensure that the belt hook is locked in position
1
|
|
|
|
|
|
|
|
2 |
|
| 3 |
|
| 4 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
USINGTHE INTEGRATED PENCIL SHARPENER
A standard pencil sharpener is integrated into the belt hook for the operator’s convenience. To sharpen a pencil, insert any standard pencil into the hole and rotate the pencil to the right (clockwise)to sharpen.
HEX WRENCH STORAGE
A 3mm hex wrench for servicing the tool is stored within the belt hook. To remove the belt hook, push out the short end of the hex wrench from the backside of the belt hook. Then grasp the hex wrench from the front of the belt hook and remove.