Coleman 024-0075CT warranty USERUSER--MAINTENANCEMAINTENANCE Instructionsinstructions

USERUSER--MAINTENANCEMAINTENANCE INSTRUCTIONSINSTRUCTIONS (continued)(continued)

Air Motor Lubrication (continued)

3.Reconnect the tool to the air supply, cover the exhaust port end with a towel and run in forward and reverse directions for approximately 30 seconds to remove excess oil.

NOTE: If the tool remains sluggish after it has been lubricated, the internal components may need to be cleaned.

To Clean:

Disconnect the air tool from the air supply and pour or spray a generous amount of WD-40® into the air inlet with the trigger depressed. Connect the tool to the air supply, cover the exhaust port end with a towel and run in forward and reverse directions for approximately 30 seconds. Follow the air motor lubrication instructions above after cleaning is completed to re-lubricate the tool.

After oiling or cleaning, cover the exhaust port with a towel and operate the tool for a few seconds to safely remove the excess oil. Clean the handle and surface of the tool of any oil residue. Failure to cover the exhaust port and clean the tool, can

result in serious injury. Note: Keep the towel away from moving parts!

Lubricate Impact Mechanism

Periodically, the impact mechanism and the front bearing needs to be lubricated. (Lubricate 3-4 times a year for general tool usage and more frequently with heavier tool usage).

1.Disconnect the air tool from the air supply.

2.Remove the allen socket screw from the oil port hole located on the side of the tool.

3.Add 1 tablespoon of Coleman Powermate® air tool oil #018-0059SP, or SAE10 nondetergent oil into the oil port hole. Replace the allen socket screw (see Figure 4).

Figure 4

4.Reconnect the tool to the air supply and run for approximately 30 seconds, rotating the tool sideways and upside down to lubricate all internal parts.

5.Disconnect the air tool from the air supply and remove the allen socket screw. Hold the oil port hole over a suitable container to allow excess oil to drain.

6.Repeat the procedure above until the oil comes out clear. Any remaining oil inside the tool will properly lubricate the tool.

7.Remember to replace the allen socket screw when lubrication is completed.

NOTES:

This lubrication procedure will help reduce moisture, dust and dirt that gradually increases inside the impact wrench during use and reduces performance levels.

TROUBLESHOOTINGG GUIDEGUIDE

SYMPTOM	POSSIBLE CAUSE(S)	CORRECTIVE ACTION
Tool will not run or runs	Grit in tool; tool gummed up	Clean the air motor inside the tool with WD-40®
slowly		(see “user maintenance” section).
	No oil in tool	Add 4-6 drops of air tool oil into the air inlet of the
		tool (see “user maintenance” section).
	Low air pressure	Adjust compressor regulator to 90 PSI.
	Torque regulator at low setting.	Adjust torque regulator knob to a higher setting.
	Air hose leaks	Tighten and seal hose fittings with Teflon® tape if
		leaks are found.

	TOOL SPECIFICATIONSTIONS
Maximum Torque	230 ft/lbs
Average SCFM Requirements	4.5 SCFM @ 90 PSI
Air Inlet	1/4” NPT (female)
Square Drive	1/2”
Recommended Hose Size	3/8”
Maximum Working Pressure	90 PSI

5 - ENG