15
C
A
B
C
17A
19
B A
knife transfer TOOL storage
The knife transfer tool (A) Fig. 15, supplied with your planer, can easily be stored underneath the outfeed table extension
(B) when not being used. A Velcro strip (C) is provided on the tool and underneath the table for this purpose.
wrench storage
The wrench (A) Fig. 16, can be stored in hole (B) located on the right rear side of the machine as shown.
carrying handle/stock transfer bar
1.Your planer is provided with a foam covered carrying handle (A) Fig. 17, located on top of the machine, for ease in transporting the planer.
2.The carrying handle (A) Fig. 18, also doubles as a stock transfer bar for transferring stock from the outfeed to infeed end of the machine. This is helpful when planing long material, as the workpiece can easily be transferred back to the infeed end of the machine for additional cuts.
replacing knives
The knives supplied with your planer are double edged and reversible, which enables you to turn the knives
16
A
B
18
A
20 | E |
D
FF
21
J
G
H
Disconnect tool from power source.
1.Raise head assembly all the way to the top.
2.Remove cutterhead guard (B) Fig. 19 by removing two knobs, one of which is shown at (A).
The knives are extremely sharp. Be careful when removing, handling or installing knives.
3.Using the supplied wrench (E) Fig. 20, unscrew the six screws at (F), only enough until locking bar (D) separates from knife, allowing knife to be removed.
8