Delta TP305 instruction manual Replacing Knives, Carrying HANDLE/STOCK Transfer BAR

CARRYING HANDLE/STOCK TRANSFER BAR

1.Your planer is provided with a foam covered carrying handle (A) Fig. 17, located on top of the machine, for ease in transporting the planer.

2.The carrying handle (A) Fig. 18, also doubles as a stock transfer bar for transferring stock from the outfeed to infeed end of the machine. This is helpful when planing long material, as the workpiece can easily be transferred back to the infeed end of the machine for additional cuts.

Fig. 17

A

Fig. 18

A

REPLACING KNIVES

The knives supplied with your planer are double edged and reversible, which enables you to turn the knives end-for-end when one edge becomes dull or chipped. To change the knives, proceed as follows:

Disconnect tool from power source.

1.Raise head assembly all the way to the top.

2.Remove cutterhead guard (B) Fig. 19 by removing two knobs, one of which is shown at (A).

The knives are sharp. Be careful when removing, handling or installing knives.

3.Using the supplied wrench (E) Fig. 20, unscrew the six screws at (F), only enough until locking bar (D) separates from knife, allowing knife to be removed.

Fig. 19

B A

Fig. 20
	E

D

F F

12