Panasonic EY6803 operating instructions Operation

. OPERATION

Chuck

NOTE: Grease for bit

Grease the oval indentation on the bit with the supplied grease at least once a month.

1. To insert the bit

1-1. Insert a bit into the mounting hole, and turn it slightly to locate an engaged position.

1-2. At the engaged position, push the bit as far as it goes. Make sure that the bit is fixed by pulling it.

SDS PLUS type

shank

2. To remove the bit

2-1. Depress the chuck cover and pull the bit.

Fastening Screws

Use a bit adapter (standard) and bit.

1.Remove the bit adapter from the bit adapter holder on the main unit.

2.Pull the bit holder. (2)

3.Insert the bit. (3)

4.Make sure the bit is inserted firmly by pulling it lightly.

5.	Insert the bit adapter into
	the mounting hole and
	turn to locate an engaged
	position.	Bit
6.	At the engaged position,	holder
	push in as far as it goes.
	• Make sure it does not move by
	pulling it lightly.

Forward/Reverse Lever

ForwardReverse

Lock

Be sure to set the switch in the center to lock it after use.

Operate the Forward/Reverse lever after the motor rotation is completely stopped.

Hammering/Drilling Switching Lever

NOTE: Operate the mode change af- ter the motor rotation is com- pletely stopped.

Position of	Action mode	Operation
switching lever
	Rotation with	Concrete
		Drilling,
	hammering
		Block Drilling
	Rotation only	Screw
		Fastening,
		Metal Drilling

Clutch Torque Setting

Adjust the torque to one of the 5 clutch settings or “ ” position.

CAUTION:

Test the setting before actual operation.

Set the scale at this mark ( ).

Variable Speed Control Trigger

To set the center of a hole, pull the trigger slightly to start the drill rotation slowly. The more the speed control trigger is pulled, the higher the speed becomes.

- -

EY6803(EU).indb 5

2006/04/10 9:41:30