Black & Decker D25600 Save These Instructions for Future USE, Motor, Side Handle and Depth Rod

582429-00/D25500 etc 1/29/03 9:29 AM Page 4

			MODEL D25550
English	A	L	B
				M
				E
	J	K	D	F
				G
			C

A	L	MODEL D25500
			E
I	K		F
B			M
		D
		H	G
		C

a.Tool Holder

b.Depth Rod

c.Side Handle

d.Clamp Knob

e.Alternate Side Handle Location

f.Trigger Switch

g.Speed Dial

h.Mode Selector

i.Locking Sleeve

j.Retaining Pin Button

k.Depth Rod Clamp Nut

l.Steel Ring

m.Service LED

SAVE THESE INSTRUCTIONS FOR

FUTURE USE

Motor

Your tool is powered by a DEWALT built motor designed to be used with alternating current. Voltage decrease of more than 10% will cause loss of power and overheating. All DEWALT tools are factory tested; if this tool does not operate, check the power supply.

Side Handle and Depth Rod

For operating convenience, the side handle can be installed in front or rear positions. Always operate the tool with the side handle properly assembled to maximize control of the tool.

TO MOUNT IN FRONT POSITION (FIG. 1)

1.Unscrew the side handle and disassemble the side handle clamp.

2.Snap the steel ring over the collar

behind the tool holder. Squeeze both ends together, mount the bushing and insert the pin.

3. Place the side handle clamp and screw on the clamp knob. Do not tighten.

4.Insert adjustable depth rod into hole.

5.Screw the side handle into the clamp knob and tighten it.

6. Rotate the side handle mounting assembly to the desired position. For

drilling horizontally with a heavy drill bit, place the side handle assembly at an angle of approximately 20˚ to the tool for optimum control.

7.Lock the side handle mounting assembly in place by tightening the clamp knob.

TO MOUNT IN REAR POSITION (FIG. 2)

1. Unscrew the side handle and remove it from the front position.

4